Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SENSOR › from 2021.02
RM33A0E _56 Audio / Visual / Telematics _065375 PARK ASSIST / MONITORING _0328092 BLIND SPOT MONITOR SENSOR A

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:
·

Avoid any impact to the blind spot monitor sensor.

·

Do not drop the blind spot monitor sensor. If it is dropped, replace it with a new one.



HINT:
·

The blind spot monitor beam axis confirmation is performed to confirm whether the sensor beam axis is correct, and to adjust the beam axis by using a reflector.

·

The blind spot monitor sensor installation condition inspection is performed to confirm whether the sensor is perpendicular to the floor surface (+/-2.2°) by using a digital angle gauge, and that the sensor is 46 to 54° from the line parallel to the vehicle center line.



PROCEDURE

Hide 88172 1.INSTALL BLIND SPOT MONITOR SENSOR LH

a.

Connect the connector.


b.

Install the blind spot monitor sensor LH with the 3 nuts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


Hide 88162 2.INSTALL BLIND SPOT MONITOR SENSOR RH

a.

Connect the connector.


b.

Install the blind spot monitor sensor RH with the 3 nuts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


Hide 3.PERFORM BLIND SPOT MONITOR SENSOR INSTALLATION CONDITION INSPECTION

Hide 4.INSTALL REAR BUMPER ASSEMBLY

Hide 5.PERFORM BLIND SPOT MONITOR BEAM AXIS CONFIRMATION