PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL
After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 85 seconds before disconnecting the cable from the negative (-) battery terminal.
IGNITION SWITCH EXPRESSIONS
The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.
| Expression | Ignition Switch
(Position) |
Engine Switch
(Condition) |
|---|---|---|
| Ignition Switch off | LOCK | Off (Lock) |
| Ignition Switch ACC | ACC | On (ACC) |
| Ignition Switch ON | ON | On (IG) |
| Engine Start | START | On (Start) |
PRECAUTION FOR AUDIO AND VISUAL SYSTEM
When replacing the telematics transceiver, be sure to replace it with a new one (w/ Telematics Transceiver).
PRECAUTIONS FOR INSPECTING POWER SOURCE FOR MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (w/ Door Control Battery)
The vehicle battery supplies power to the main body ECU (multiplex network body ECU) via the door control battery. If a main body ECU (multiplex network body ECU) power source malfunction occurs, the door control battery may be malfunctioning.