This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
89615
1.INSTALL KNOCK CONTROL SENSOR
Perform "Inspection After Repair" after replacing the knock control sensor.
w/ Canister Pump Module
Click hereEngine / Hybrid System>A25A-FKS (ENGINE CONTROL)>SFI SYSTEM (w/ Canister Pump Module)>INITIALIZATION
w/o Canister Pump Module
| *a | Top |
| *b | Right of Vehicle |
| *c | 15° |
| *d | 5° |
Install the knock control sensor to the cylinder block sub-assembly with the bolt so that the knock control sensor installation position is as shown in the illustration.
If the knock control sensor has been struck or dropped, replace it.
Make sure that the knock control sensor is in the correct position.
Connect the knock control sensor connector.
27020
2.INSTALL GENERATOR ASSEMBLY
for 100 A, 130 A Type
Click herePower Source / Network>A25A-FKS (BATTERY / CHARGING)>GENERATOR (for 100 A, 130 A Type)>INSTALLATION
for 150 A Type
Click herePower Source / Network>A25A-FKS (BATTERY / CHARGING)>GENERATOR (for 150 A Type)>INSTALLATION
3.PERFORM INITIALIZATION
Perform "Inspection After Repair" after replacing the knock control sensor.
w/ Canister Pump Module
Click hereEngine / Hybrid System>A25A-FKS (ENGINE CONTROL)>SFI SYSTEM (w/ Canister Pump Module)>INITIALIZATION
w/o Canister Pump Module