This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
53851M
1.REMOVE FRONT WHEEL OPENING EXTENSION PAD RH (w/ Cover)
53852K
2.REMOVE FRONT WHEEL OPENING EXTENSION PAD LH (w/ Cover)
51441
3.REMOVE NO. 1 ENGINE UNDER COVER (w/ Cover)
4.REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY (w/ Cover)
5.DRAIN ENGINE OIL
12102A
6.REMOVE NO. 2 OIL PAN SUB-ASSEMBLY
89491
7.REMOVE ENGINE OIL LEVEL SENSOR
Disconnect the engine oil level sensor connector.
Remove the clip from the engine oil level sensor.
Using an 8 mm socket wrench, remove the 2 bolts and engine oil level sensor from the engine balancer assembly.