1.REMOVE FRONT WHEEL LH (for LHD)
2.REMOVE FRONT WHEEL RH (for RHD)
53852K
3.REMOVE FRONT WHEEL OPENING EXTENSION PAD LH (for LHD)
Use the same procedure as for the RH side.
Click hereVehicle Exterior>WIPER / WASHER>WASHER MOTOR>REMOVAL
53851M
4.REMOVE FRONT WHEEL OPENING EXTENSION PAD RH (for RHD)
76622C
5.REMOVE FRONT FENDER MUDGUARD LH (for LHD)
w/ Mudguard:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>MUDGUARD>REMOVAL
76621C
6.REMOVE FRONT FENDER MUDGUARD RH (for RHD)
w/ Mudguard:
Use the same procedure as for the LH side.
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>MUDGUARD>REMOVAL
53876A
7.REMOVE FRONT FENDER LINER LH (for LHD)
Use the same procedure as for the RH side.
Click hereVehicle Exterior>WIPER / WASHER>WASHER MOTOR>REMOVAL
53875A
8.REMOVE FRONT FENDER LINER RH (for RHD)
53295E
9.REMOVE COOL AIR INTAKE DUCT SEAL
53510
10.REMOVE HOOD LOCK ASSEMBLY
for LHD:
w/ Engine Hood Courtesy Switch:
Disconnect the connector.
| *a | Protective Tape |
Using a screwdriver with its tip wrapped with protective tape, remove the hood lock nut cap.
| *1 | Hood Lock Bolt |
Remove the 2 bolts and hood lock bolt.
Disconnect the hood lock control cable assembly to remove the hood lock assembly.
for RHD:
Disconnect the connector.
| *a | Protective Tape |
Using a screwdriver with its tip wrapped with protective tape, remove the hood lock nut cap.
| *1 | Hood Lock Bolt |
Remove the 2 bolts and hood lock bolt.
Disconnect the hood lock control cable assembly to remove the hood lock assembly.
67914
11.REMOVE FRONT DOOR SCUFF PLATE LH (for LHD)
62112A
12.REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH (for LHD)
55606
13.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for LHD)
55606
14.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for RHD)
53601
15.DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
53601
16.REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Disconnect the hood lock control cable assembly to remove the hood lock control lever sub-assembly.
53630
17.REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY
for LHD:
Disengage the clamp.
Using a screwdriver, disengage the 4 clamps and grommet as shown in the illustration.
| *1 | Hood Lock Control Cable Assembly | - | - |
| *a | Clamp | *b | Grommet |
Tape the screwdriver tip before use.
Pull the hood lock control cable assembly from the engine compartment to remove it.
for RHD:
Using a screwdriver, disengage the 4 clamps and grommet as shown in the illustration.
| *1 | Hood Lock Control Cable Assembly | - | - |
| *a | Clamp | *b | Grommet |
Tape the screwdriver tip before use.
Pull the hood lock control cable assembly from the engine compartment to remove it.