Home › Steering › STEERING COLUMN › STEERING COLUMN ASSEMBLY (for Manual Tilt and Manual Telescopic Steering Column) › from 2022.01
RM33A0E _55 Steering _065371 STEERING COLUMN _0319591 STEERING COLUMN ASSEMBLY(for Manual Tilt and Manual Telescopic Steering Column) A

STEERING COLUMN  STEERING COLUMN ASSEMBLY(for Manual Tilt and Manual Telescopic Steering Column)  DISASSEMBLY  


CAUTION / NOTICE / HINT

NOTICE:

w/ Smart Key System:

Before replacing the steering lock actuator assembly, refer to Service Bulletin.


PROCEDURE

Hide 1.REMOVE UPPER STEERING COLUMN BRACKET WITH SWITCH ASSEMBLY (w/o Entry and Start System)

a.

Secure the steering column assembly in a vise between aluminum plates.

NOTICE:

Do not overtighten the vise.



b.

Using a drill, drill a hole in the 2 steering lock set bolts and insert a screw extractor.


c.
C373460

Using the screw extractor, remove the 2 steering lock set bolts, upper steering column clamp and upper steering column bracket with switch assembly.


Hide 45020B 2.REMOVE STEERING LOCK ACTUATOR ASSEMBLY (w/ Entry and Start System with Steering Lock Actuator Assembly)

HINT:

Perform the same procedure as for the upper steering column bracket with switch assembly (w/o Smart Key System).


Hide 3.REMOVE IGNITION SWITCH LOCK CYLINDER ASSEMBLY (w/o Entry and Start System)

a.
C373469C01
0.74,0.833 1.052,0.99 0.313,0.156 10 false *a 0.542,0.427 0.854,0.583 0.313,0.156 10 false *b
*a LOCK
*b ACC
V113147

Push
V113148

Pull


Turn the ignition switch to ACC.


b.

Insert the tip of a screwdriver into the hole in the upper steering column bracket assembly, as shown in the illustration, and pull out the ignition switch lock cylinder assembly.


Hide 84052 4.REMOVE UN-LOCK WARNING SWITCH ASSEMBLY (w/o Entry and Start System)

a.
C373470C01
1.24,2.552 1.75,2.552 true 1.792,2.469 2.104,2.625 0.313,0.156 10 false *a
*a Center Part


Remove the un-lock warning switch assembly by pushing up the center part and releasing the 2 claws.

HINT:

Slide the un-lock warning switch assembly in the direction shown by the arrow in the illustration to remove it.



Hide 84450 5.REMOVE IGNITION OR STARTER SWITCH ASSEMBLY (w/o Entry and Start System)

a.
C373885

Disengage the 2 claws and remove the ignition or starter switch assembly from the upper steering column bracket assembly.