Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › BRAKE CONTROL SYSTEM
NM33C0E _54 Brake _067423 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0330428 BRAKE CONTROL SYSTEM CO CONTROL F

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  BRAKE CONTROL SYSTEM  CONTROL  SECONDARY COLLISION BRAKE  


SYSTEM CONTROL


a.

The secondary collision brake system lessens damage from a secondary collision by controlling the automatic brakes and stop light illumination after a collision occurs.


b.

When the airbag sensor assembly detects a collision and operates the airbags, it sends a collision detection signal to the skid control ECU. When the skid control ECU receives a collision detection signal, it determines that operation can start, operates the brake actuator and performs braking. Simultaneously, the skid control ECU sends a stop light illumination request to the stop light switch assembly, illuminating the stop lights.

X137418E01
2.177,4.469 2.375,4.469 2.375,4.469 2.635,4.25 false 3.021,0.167 4.208,0.823 1.188,0.656 10 false Brake Booster with Master Cylinder Assembly 0.365,1.24 2.021,1.771 1.656,0.531 10 false Airbag Sensor Assembly 0.417,1.76 1.813,2.333 1.396,0.573 10 false Hybrid Vehicle Control ECU Assembly 0.396,2.594 2.26,3.115 1.865,0.521 10 false Network Gateway ECU 0.208,3.479 2.073,4 1.865,0.521 10 false Combination Meter Assembly 0.302,3.979 2.167,4.5 1.865,0.521 10 false Brake Actuator Assembly 5.052,4.313 6.844,4.542 1.792,0.229 10 false : CAN Communication Line 3.188,1.708 3.979,2.177 0.792,0.469 10 false Skid Control ECU 4.531,1.479 5.385,1.969 0.854,0.49 10 false Wheel Speed Signal 4.417,2.375 5.438,3.167 1.021,0.792 10 false Stop Light Illumination Request Signal 5.813,1.271 6.865,1.542 1.052,0.271 10 false Speed Sensor 5.771,2.042 6.875,2.552 1.104,0.51 10 false Stop Light Switch Assembly 5.979,3.302 6.802,3.615 0.823,0.313 10 false Stop Light 5.531,2.719 6.271,3.25 0.74,0.531 10 false Stop Lights Illumination 0.156,4.406 2.271,4.646 2.115,0.24 10 false Brake Operation Request Signal


c.

Secondary Collision Brake Operation Start Condition

i.

When a collision detection signal is received from the airbag sensor assembly while the vehicle speed is approximately 10 km/h or more, the secondary collision brake starts operating.

HINT:

When a system malfunction is displayed on the multi-information display or the system is in test mode or maintenance mode, the secondary collision brake is prohibited from operating.




d.

Secondary Collision Brake Operation Cancellation Condition

i.

If one of the following conditions is detected, operation of the secondary collision brake is canceled.

Secondary Collision Brake Operation Cancellation Conditions
·

The vehicle speed is below approximately 10 km/h.

·

Operation continues for a certain period of time.

·

After operating, the accelerator pedal is depressed a certain amount or more.