OUTLINE
The automatic air conditioning system uses left and right independent temperature control and neural network control to enhance comfort.
An inside-and-outside dual air layer type air conditioning unit is used.
HFC-134a refrigerant is used.
The automatic air conditioning system uses driver, front passenger and rear passenger* independent temperature control to enhance comfort.
*: Models with 3-zone control
SPECIFICATION
Ventilation and Heater Core
| Heater Radiator Unit Sub-assembly | Type | Straight Flow Aluminum (SFA) - II | |
| Size (W x H x L) | mm (in.) | 263.9 x 120 x 27
(10.4 x 4.7 x 1.1) |
|
| Blower with Fan Motor Sub-assembly | Motor Type | DC Ferrite Brushless | |
| Fan Type | Semi Sirocco | ||
| Fan Size (Dia. x H) | mm (in.) | Upper Side: 122.0 x 55.0 (4.8 x 2.2)
Lower Side: 125.0 x 38.0 (4.9 x 1.5) |
|
Air Conditioning
|
*1: Except destination package for South Korea *2: Destination package for South Korea |
|||
| Cooler Condenser Assembly | Type | Global Inner-fin Condenser (GIC) | |
| Size (W x H x L) | mm (in.) | 700 x 453 x 11.5
(27.6 x 17.8 x 0.5) |
|
| Fin Pitch | mm (in.) | 3.0 (0.12) | |
| Compressor with Motor Assembly | ESB27 | ||
| Refrigerant | Type | HFC-134a | |
| Evaporator | Type | Ejector Cycle System (ECS) Evaporator*1 | |
| Beneficial Refrigerant Stream (BRS) Evaporator*2 | |||
| Size (W x H x L) | mm (in.) | 279.7 x 231.0 x 38.0 (11.0 x 9.1 x 1.5) | |
| Fin Pitch | mm (in.) | 3.0 (0.12) | |
MAIN FEATURES
The air conditioning system has the following features:
|
*1: Except destination package for South Korea *2: Destination package for South Korea |
|
| High Performance | ·
A high efficiency type clean air filter, which has a pollen-and-odor removal effect, is used. ·
The rear outlets are installed on the back of the center console to ensure comfortable cooling performance for the rear passengers. ·
The blower control has 7 levels in manual mode and 31 levels in auto mode for more precise control. |
| Lightweight | ·
An air conditioning harness assembly with a built-in communication/driver IC is used in a lightweight wire harness design to allow a reduced number of wires. ·
The use of this type of connector means that pulse pattern type servo motors can be used. |
| Compact | A blower motor with a built-in blower motor controller is used to achieve a compact construction. |
| Others | The following parts are used to ensure high cooling performance while realizing a compact and lightweight construction.
·
Semi-center Location Air Conditioning Unit ·
Ejector Cycle System (ECS) Evaporator*1 ·
Beneficial Refrigerant stream (BRS) Evaporator*2 ·
Straight Flow Aluminum (SFA)-II Heater Radiator Sub-assembly ·
Global Inner-fin Condenser (GIC) Sub-cool Condenser |