Home › General › INTRODUCTION › FEATURES
NM33C0E _V1 General _068185 INTRODUCTION _0334002 FEATURES GE GENERAL F

INTRODUCTION  FEATURES  GENERAL  PERFORMANCE  


OUTLINE


a.

Hybrid System

i.

The hybrid system of this hybrid vehicle employs the Toyota Hybrid System-II (THS-II) under the "Hybrid Synergy Drive" concept*.


ii.

Toyota Hybrid System-II (THS-II) optimally performs cooperative control of the A25A-FXS engine, Motor Generator No. 1 (MG1) and Motor Generator No. 2 (MG2) in the P710 hybrid transaxle that provides excellent transmission performance for the front wheel drive system.


iii.

The hybrid system uses a high-output HV battery with a nominal voltage of DC 245 and available voltage system in which a boost converter increases the operating voltage of the system to a maximum voltage of DC 650 V.

HINT:

*: The "Hybrid Synergy Drive" concept consists of 4 key benefits: Fuel efficiency, low emissions, seamless acceleration, and silent performance.




b.

A25A-FXS Engine

i.

The A25A-FXS engine is an in-line 4-cylinder, 2.5 liter, 16 valve DOHC engine. The engine adopts the Variable Valve Timing-intelligent system which realizes optimal valve timing by using electric motors to actuate the intake camshaft actuators (VVT-iE) and engine oil pressure to actuate the exhaust camshaft actuators (VVT-i). In addition, this engine uses a high-expansion ratio Atkinson cycle, Direct injection 4-stroke gasoline engine Superior version (D-4S) system, Direct Ignition System (DIS), Electronic Throttle Control System-intelligent (ETCS-i) and Exhaust Gas Recirculation (EGR) system employing a highly efficient EGR cooler. Thus, improved engine performance, quietness, fuel economy, and cleaner emissions have been achieved.

Item Specification
No. of Cyls. and Arrangement 4-cylinder, In-line
Valve Mechanism 16-valve DOHC, Chain Drive (With VVT-iE and VVT-i)
Fuel System Sequential Multiport Fuel Injection (SFI) D-4S
Displacement cm3 (cu. in.) 2487 (151.8)
Max. Output (EEC) kW@rpm 131@5700
Max. Torque (EEC) N*m@rpm 221@3600 to 5200



c.

P710 Hybrid Vehicle Transaxle

i.

The P710 hybrid transaxle is used.



d.

Suspension

i.

A MacPherson strut type independent suspension, which has L-type lower arms is used for the front.


ii.

A double wishbone type independent suspension, which consists of an upper control arm, 2 lower suspension arms and a trailing arm is used for the rear.



e.

Steering

i.

A rack and pinion type steering gear assembly is used.


ii.

An Electric Power Steering (EPS) system is used.


iii.

A manual tilt and manual telescopic mechanism and a power tilt and power telescopic system are available.



f.

Brake

i.

A ventilated disc brake is provided for the front brake.


ii.

A solid disc brake is provided for the rear brake.


iii.

An electric parking brake system is used.


iv.

The following brake control functions are provided: Anti-lock Brake System (ABS), Electronic Brake force Distribution (EBD), Brake Assist, Traction Control (TRC), Vehicle Stability Control (VSC), Hill-start Assist Control, Brake Hold, Enhanced-VSC and Secondary Collision Brake*.

*: Models with secondary collision brake system