Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM › 2018.04–2021.02
NM33C0E _58 Vehicle Interior _068285 HEATING / AIR CONDITIONING _0332682 AIR CONDITIONING SYSTEM GE GENERAL F

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM  GENERAL  GENERAL  


OUTLINE


a.

The automatic air conditioning system uses left and right independent temperature control and neural network control to enhance comfort.


b.

An inside-and-outside dual air layer type air conditioning unit is used.


c.

HFC-134a refrigerant is used.


d.

The automatic air conditioning system uses driver, front passenger and rear passenger* independent temperature control to enhance comfort.

*: Models with 3-zone control



SPECIFICATION


a.

Ventilation and Heater Core

*1: Models with dual air layer type air conditioning unit

*2: Models with single air layer type air conditioning unit

Heater Radiator Unit Sub-assembly Type Straight Flow Aluminum (SFA) - II
Size (W x H x L) mm (in.) 263.9 x 120 x 27
(10.4 x 4.7 x 1.1)
Blower with Fan Motor Sub-assembly*1 Motor Type DC Ferrite Brushless
Fan Type Semi Sirocco
Fan Size (Dia. x H) mm (in.) Upper Side: 122.0 x 55.0 (4.8 x 2.2)
Lower Side: 125.0 x 38.0 (4.9 x 1.5)
Blower with Fan Motor Sub-assembly*2 Motor Type DC Ferrite Brushless
Fan Type Semi Sirocco
Fan Size (Dia. x H) mm (in.) 137.0 x 70.0 (5.4 x 2.8)


b.

Air Conditioning

*1: Except models for middle east and destination package for South Korea

*2: Models for middle east and destination package for South Korea

Cooler Condenser Assembly Type Global Inner-fin Condenser (GIC)
Size (W x H x L) mm (in.) 700 x 453 x 11.5
(27.6 x 17.8 x 0.5)
Fin Pitch mm (in.) 3.0 (0.12)
Compressor with Motor Assembly ESB27
Refrigerant Type HFC-134a
Evaporator Type Ejector Cycle System (ECS) Evaporator*1
Beneficial Refrigerant Stream (BRS) Evaporator*2
Size (W x H x L) mm (in.) 279.7 x 231.0 x 38.0 (11.0 x 9.1 x 1.5)
Fin Pitch mm (in.) 3.0 (0.12)



MAIN FEATURES


a.

The air conditioning system has the following features:

*1: Except models for middle east and destination package for South Korea

*2: Models for middle east and destination package for South Korea

High Performance
·

A high efficiency type clean air filter, which has a pollen-and-odor removal effect, is used.

·

The rear outlets are installed on the back of the center console to ensure comfortable cooling performance for the rear passengers.

·

The blower control has 7 levels in manual mode and 31 levels in auto mode for more precise control.


Lightweight
·

An air conditioning harness assembly with a built-in communication/driver IC is used in a lightweight wire harness design to allow a reduced number of wires.

·

The use of this type of connector means that pulse pattern type servo motors can be used.


Compact A blower motor with a built-in blower motor controller is used to achieve a compact construction.
Others The following parts are used to ensure high cooling performance while realizing a compact and lightweight construction.
·

Semi-center Location Air Conditioning Unit

·

Ejector Cycle System (ECS) Evaporator*1

·

Beneficial Refrigerant stream (BRS) Evaporator*2

·

Straight Flow Aluminum (SFA)-II Heater Radiator Sub-assembly

·

Global Inner-fin Condenser (GIC) Sub-cool Condenser