CONSTRUCTION
The pistons are made of aluminum alloy to allow them to be compact and lightweight.
A piston with a concave top surface is used to prevent air turbulence and to realize high speed combustion. This contributes to the prevention of engine knock which enables a high compression ratio, resulting in increased performance and reduced fuel consumption.
The casting process and the structure of the piston has been optimized, realizing thinner inner walls and resulting in a drastic weight reduction.
The skirt portion of the piston has a resin coating to ensure a smooth surface. By minimizing bore friction, protection against scuffing is enhanced.
A Diamond Like Carbon (DLC) coating have been applied to the surface of the No. 1 compression ring, in order to reduce friction losses and improve wear resistance.
A Physical Vapor Deposition (PVD) coating have been applied to the surface of the oil ring side rail, in order to reduce friction losses and improve wear resistance.
The groove of the No. 1 compression ring is coated with alumite to ensure abrasion resistance.
To prevent increased oil consumption at high engine speeds, an asymmetric barrel design has been adopted for the outer circumference of the side rails of the oil ring. As well as realizing a drastic reduction in oil consumption, friction has been reduced due to optimization of the oil ring tension.
An oil ring expander which utilizes punched grooves to prevent deposits from accumulating is used. Oil flow between the expander and side rails is enhanced, realizing a structure that prevents deposits from accumulating.
| *1 | No. 1 Compression Ring | *2 | No. 2 Compression Ring |
| *3 | Oil Ring | - | - |
| *a | Front Mark | *b | Alumite Coating |
| *c | Resin Coating | *d | DLC Coating |
| *e | PVD Coating | *f | Combustion Bowl |
By tilting the sidewalls of the piston towards the piston center, the combustion pressure is better distributed to the piston pin. This allows for higher power output capability.
| *a | Tilted Sidewall | - | - |