CONSTRUCTION
The HV battery mainly consists of the HV battery (2 battery stacks), No. 1 and No. 2 HV battery voltage detection wire, hybrid battery junction block assembly, battery cooling blower assembly, battery ECU assembly and service plug grip.
The HV battery uses aluminum container type cells. As a result, high power density, lightweight construction, and longevity have been accomplished at high levels.
The battery cooling blower assembly is used as a dedicated cooling system to ensure that the HV battery performs properly, despite it generating significant heat during the repetitive charge and discharge cycles.
| *1 | Battery Cooling Blower Assembly | *2 | No. 1 HV Battery Voltage Detection Wire |
| *3 | Battery ECU Assembly | *4 | Hybrid Battery Junction Block Assembly |
| *5 | Service Plug Grip | *6 | No. 2 HV Battery Voltage Detection Wire |
| *7 | HV Battery (Battery stack) | - | - |
Compact, lightweight 3.7 V lithium-ion battery cells are used in order to generate high power output.
| *1 | Positive Terminal | *2 | Negative Terminal |
The 35 lithium-ion battery cells provided for each hybrid battery stack are connected in series in a bus bar module.
The HV battery consists of 2 hybrid battery stacks. They are connected to each other in series through bus bar modules and wiring harness.
No. 1 HV Battery Voltage Detection Wire and No. 2 HV Battery Voltage Detection Wire
3 thermistor type battery temperature sensors are provided in each the HV battery detection wires.
The thermistor type intake air temperature sensors is provided in No. 1 HV battery voltage detection wire to detect the temperature of the cooling air.
The battery ECU assembly optimally controls the cooling system so that the HV battery temperature can be within a specified range according to the temperature information.
| *1 | No. 1 HV Battery Voltage Detection Wire | *2 | No. 2 HV Battery Voltage Detection Wire |
| *a | HV Battery Temperature Sensor | *b | HV Battery Intake Air Temperature Sensor |