Home › Engine / Hybrid System › A25A-FXS (ENGINE CONTROL) › SFI SYSTEM › from 2020.08
NM33C0E _51 Engine / Hybrid System _068016 A25A-FXS ENGINE CONTROL _0331671 SFI SYSTEM DE DETAILS F

A25A-FXS ENGINE CONTROL  SFI SYSTEM  DETAILS  CRANKSHAFT POSITION SENSOR  


CONSTRUCTION


a.

A Magnetic Resistance Element (MRE) type crank position sensor is used to detect the engine speed and crankshaft angle.


b.

The crank angle sensor plate (timing rotor) of the crankshaft consists of 34 teeth with 2 teeth missing. The crank position sensor outputs a crankshaft rotation signal every 10°, and the change of the signal due to the missing teeth is used to determine top-dead-center.

W146594E02
1.333,1.25 1.75,1.25 1.75,1.25 3.833,2.833 true 1.417,3.5 4.25,3.5 true 0.365,1.146 1.323,1.594 0.958,0.448 10 false Crank Position Sensor 0.083,3.385 1.354,3.792 1.271,0.406 10 false Crank Angle Sensor Plate 1.24,5.792 3.51,6.021 2.271,0.229 10 false Crank Angle Sensor Plate (360° CA) 0.552,6.24 0.74,6.448 0.188,0.208 10 false Hi 0.552,6.885 0.74,7.094 0.188,0.208 10 false Lo 1.708,7.083 2.917,7.333 1.208,0.25 10 false Output Waveforms 4.615,7.208 6.26,7.469 1.646,0.26 10 false Crank Angle Sensor Plate 6.354,5.813 6.854,6.042 0.5,0.229 10 false 30° CA 6.438,6.25 6.938,6.479 0.5,0.229 10 false 10° CA


c.

An MRE type crank position sensor consists of an MRE, a magnet and a sensor. The direction of the magnetic field changes due to the profile (protruding and non-protruding portions) of the crank angle sensor plate, which passes by the sensor. As a result, the resistance of the MRE changes, and the output voltage to the ECM changes to high or low. The ECM detects the crankshaft position based on this output voltage.