Home › Vehicle Exterior › VEHICLE PROXIMITY NOTIFICATION SYSTEM › VEHICLE PROXIMITY NOTIFICATION SYSTEM › from 2020.08
NM33C0E _59 Vehicle Exterior _075981 VEHICLE PROXIMITY NOTIFICATION SYSTEM _0369610 VEHICLE PROXIMITY NOTIFICATION SYSTEM CO CONTROL F

VEHICLE PROXIMITY NOTIFICATION SYSTEM  VEHICLE PROXIMITY NOTIFICATION SYSTEM  CONTROL  VEHICLE PROXIMITY NOTIFICATION CONTROL  


FUNCTION OF MAIN COMPONENTS


Component Function
Vehicle Approaching Speaker Controller Controls starting and stopping of operation, sound pitch and volume level based on signals received from the hybrid vehicle control ECU and skid control ECU.
Vehicle Approaching Speaker Assembly Emits warning sounds based on the operation signal received from the vehicle approaching speaker controller.
Hybrid Vehicle Control ECU
·

Outputs a shift position signal to the vehicle approaching speaker controller.

·

Outputs an engine running signal to the vehicle approaching speaker controller.

·

Outputs a stop light switch signal to the vehicle approaching speaker controller.

·

Outputs a front motor speed signal to the vehicle approaching speaker controller.


Combination Meter Assembly
·

Multi-information Display


Displays a warning message when there is a malfunction in the vehicle proximity notification system.
Brake Booster with Master Cylinder Assembly
·

Skid Control ECU


Outputs a vehicle speed signal to the vehicle approaching speaker controller.
Network Gateway ECU Transmits the signal between the CAN communication bus.


OPERATING CONDITION


Condition Outline
System Active The vehicle proximity notification system operates (emits a warning sound) when all of the following conditions are met:
·

The shift position is any position other than P.

·

The engine is stopped.

·

The vehicle speed is 25 km/h (15 mph) or less.

·

The vehicle speed exceeds 0 km/h (0 mph), or stop light switch is turned from on to off.


System Stop The vehicle proximity notification system stops operating when any of the following conditions is met:
·

The shift position is P.

·

The engine starts.

·

The vehicle speed is more than 25 km/h (15 mph).

·

With a vehicle speed of 0 km/h (0 mph), front motor speed of 32 rpm or less, and the stop light switch on signal is received continuously for more than approximately 0.24 second.

·

With a vehicle speed of 0 km/h (0 mph), front motor speed of 32 rpm or less, and the stop light switch off signal is received continuously for more than approximately 3 seconds.



HINT:

All conditions are the same when the vehicle reverses.



SYSTEM CONTROL


Control Outline
Vehicle Speed Linked Control
·

Emits the warning sound by controlling the pitch of the sound in accordance with the vehicle speed.

·

The warning sound becomes higher as the vehicle accelerates and it becomes lower as the vehicle decelerates.


Fade-in/Fade Out Control When the system starts operating, the warning sound volume gradually increases, and when system operation is stopped, the sound volume gradually decreases.


FUNCTION


a.

Warning Indication

i.

The combination meter assembly uses the multi-information display to notify the driver of vehicle proximity notification system malfunctions.


ii.

When the system is not available, the following warning occurs to warn the driver.

When a system malfunction is detected
Multi-information Display Detail DTC
Proximity Notification System Malfunction Visit Your Dealer This message appears when the vehicle approaching speaker controller detects a system malfunction Repair is required DTCs are stored




DIAGNOSIS


a.

The vehicle approaching speaker controller will also store Diagnostic Trouble Codes (DTCs). The DTCs can be read by using the Global Techstream (GTS). For details, refer to the Repair Manual.