FUNCTION OF MAIN COMPONENTS
| Item | Function |
|---|---|
| Radiator Shutter Sub-assembly | The fins of the radiator shutter sub-assembly are closed by the swing grille actuator assembly to block the airflow to the engine compartment. |
| Swing Grille Actuator Assembly | Actuates the radiator shutter sub-assembly based on the control signal from the ECM via LIN communication. |
| Air Conditioning Amplifier Assembly | Sends the A/C refrigerant pressure signal and outside temperature signal to the ECM via CAN communication. |
| Hybrid Vehicle Control ECU Assembly | Sends a vehicle speed signal, inverter coolant temperature signal and shift B position request signal to the ECM via CAN communication. |
| ECM | ·
Controls the swing grille actuator Assembly based on the signal from the engine coolant temperature signals, air conditioning amplifier assembly, and hybrid vehicle control ECU assembly via LIN communication. ·
Sends a diagnosis signal to the combination meter assembly when a malfunction is detected. |
| Combination Meter Assembly | Displays a message on the multi-information display to alert the driver with a signal provided by the ECM. |
| Central Gateway ECU (Network Gateway ECU) | Relays data between buses. |
OPERATION
ECM does the cold condition control while the engine coolant temperature and hybrid inverter coolant temperature is low.
ECM does the high speed traveling control.
| Item | Description |
|---|---|
| Cold Condition Control | ·
When the power switch is ON (READY) at the engine coolant temperature is below 40 °C (104 °F) , the grille shutter is closed until the engine coolant temperature at the 75 °C (167 °F). ·
Using the air conditioner in low outside temperature, the grille shutter is opened when the pressure of the refrigerant becomes higher. |
| High Speed Traveling Control | ·
Vehicle traveling speed is between approximately 37 to 93 mph (60 to 150 km/h), the grille shutter is closed. ·
When the vehicle is traveling and engine coolant temperature is approximately 97 °C (207 °F) or more, the grille shutter is opened. ·
When the vehicle is traveling and outside temperature is approximately 35 °C (95 °F) or more, the grille shutter is opened. ·
When the vehicle is traveling and air conditioning refrigerant pressure is high, the grille shutter opens and closes in accordance with the vehicle speed and the outside air temperature, etc. |
Sometimes, the grille shutter operates after the power switch turned on (IG) or turned off. This does not indicate a malfunction.
FUNCTION
Warning Indication
The combination meter assembly uses the multi-information display, master warning light and buzzer to provide the driver with grille shutter system malfunction.
When the system is not available, the following warning occurs to warn the driver.
| Multi-information Display | Detail | Master Warning Light | Buzzer | DTC |
|---|---|---|---|---|
| Grille Shutter Inoperative.
Visit Your Dealer |
This message appears when the swing grille actuator assembly detects a system malfunction | Illuminates | Sounds once | Repair is required DTCs are stored |
| Grille Shutter not Initialized.
Cancel Maintenance Mode. |
This message appears when the swing grille actuator assembly detects a maintenance mode | Illuminates | - | - |
The maintenance mode can be cancel using the Techstream or driving the vehicle. For details, refer to the Repair Manual.
DIAGNOSIS
If the ECM detects a malfunction in the grille shutter system, Diagnostic Trouble Codes (DTCs) are stored in the ECM.
The 5-digit DTCs can be read by connecting the Global TechStream (GTS) to the DLC3. For details, refer to the Repair Manual.