FUNCTION OF MAIN COMPONENTS
| Component | Function | |
|---|---|---|
| Flow Shutting Valve (Water Valve) | Selects a coolant passage based on signals from the ECM. | |
| Engine Water Pump Assembly (Water Inlet Housing) | Optimizes coolant circulation based on signals from the ECM. | |
| Water Inlet with Thermostat Sub-assembly | Thermostat | Opens and closes the valve based on expansion and contraction of the wax in accordance with the coolant temperature. |
| Engine Coolant Temperature Sensor | Detects the engine coolant temperature. | |
FUNCTION
By using the variable cooling system that consists of the thermostat with heater, engine water pump assembly (water inlet housing) and flow shutting valve (water valve), engine warm-up capability has been enhanced, friction has been reduced and low fuel consumption has been achieved.
| *a | The engine coolant flow rate is less than standard when the thermostat is closed. When the air conditioning system is operating, the flow rate required by the air conditioning system is used if it is higher than the standard flow rate. | *b | After the thermostat opens, the engine coolant flow rate remains the same until the engine is subjected to high load, at which time the flow rate is increased. The engine coolant flow rate is not decreased below the standard flow rate. When the air conditioning system is operating, the flow rate required by the air conditioning system is used if it is higher than the standard flow rate. |
| *c | The temperature at which the cooling fan starts operating changes depending on the engine conditions. | - | - |
When the engine is warming up
The engine coolant flow rate is controlled at less than the standard flow rate based on the engine temperature.
| *1 | Engine | *2 | Flow Shutting Valve (Water Valve) (Open) |
| *3 | Heater Radiator Unit Sub-assembly | *4 | Engine Water Pump Assembly (Water Inlet Housing) |
| *5 | Water Inlet with Thermostat Sub-assembly
·
Thermostat |
*6 | Radiator Assembly |
| *a | EGR Cooler Assembly, etc. | - | - |
When the engine is warm (after the thermostat opens)
During high load, the engine coolant flow rate is controlled at more than the standard flow rate depending on the coolant temperature in order to prevent knocking.
| *1 | Engine | *2 | Flow Shutting Valve (Water Valve) (Open) |
| *3 | Heater Radiator Unit Sub-assembly | *4 | Engine Water Pump Assembly (Water Inlet Housing) |
| *5 | Water Inlet with Thermostat Sub-assembly
·
Thermostat |
*6 | Radiator Assembly |
| *a | EGR Cooler Assembly, etc. | - | - |
When the air conditioning system is operating.
The flow of engine coolant to the heater radiator unit sub-assembly is stopped in order to improve the cooling efficiency of the air conditioning system.
| *1 | Engine | *2 | Flow Shutting Valve (Water Valve) (Closed) |
| *3 | Heater Radiator Unit Sub-assembly | *4 | Engine Water Pump Assembly (Water Inlet Housing) |
| *5 | Water Inlet with Thermostat Sub-assembly
·
Thermostat |
*6 | Radiator Assembly |
| *a | EGR Cooler Assembly, etc. | - | - |