CONSTRUCTION
The spring rate of the coil spring is optimized to achieve excellent controllability and ride comfort.
Spring insulators are provided at the top and bottom ends of the rear coil springs to ensure excellent vibration suppression.
A low-pressure (N2) gas sealed rear shock absorber assembly is used to achieve a high level of controllability, driving stability and ride comfort.
To prevent hazardous conditions, make sure to empty the gas from the shock absorber before discarding the low-pressure (N2) gas sealed in the shock absorber. For details, refer to the Repair Manual.
A resin absorber cap is used to reduce weight.
Except Models for Europe or Models without Sport Suspension
The digressive type piston valve opens in 2 different stages according to the piston speed to ensure an optimal damping force at very low piston speeds and middle/high piston speeds.
As only the stage 1 valve opens at very low piston speeds to ensure sufficient damping force even during minor movements, an enhanced response and comfortable flat ride have been achieved.
At middle/high piston speeds such as during a strong input, the stage 1 and stage 2 valves open to reduce the damping force in order to increase ride comfort and reduce transmitted shock.
| *1 | Absorber Cap | *2 | Rebound Stopper |
| *3 | Digressive Type Piston Valve | *4 | Base Valve |
| *5 | Oil | *6 | Low-pressure (N2) Gas |
| *7 | Oil Seal | - | - |
| *a | Extension Passage | *b | Very Low Piston Speed |
| *c | Middle/High Piston Speed | - | - |
Models for Europe or Models with Sport Suspension
By optimizing the friction of the shock absorber, a rear shock absorber assembly that is responsive right from the start of movement has been achieved. As sufficient damping force can be obtained even at very low piston speeds, an enhanced steering response, comfortable flat ride and high quality feel have been achieved.
| *1 | Absorber Cap | *2 | Rebound Stopper |
| *3 | Multi-leaf Type Linear Control Valve | *4 | Base Valve |
| *5 | Oil | *6 | Low-pressure (N2) Gas |
| *7 | Oil Seal | - | - |
| *a | Extension Passage | *b | Compression Passage |