Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM › from 2021.02
NM33C0E _58 Vehicle Interior _068285 HEATING / AIR CONDITIONING _0332682 AIR CONDITIONING SYSTEM GE GENERAL F

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM  GENERAL  GENERAL  


OUTLINE


a.

The automatic air conditioning system uses left and right independent temperature control and neural network control to enhance comfort.


b.

An inside-and-outside dual air layer type air conditioning unit is used.


c.

HFO-1234yf or HFC-134a refrigerant is used depending on the models.


d.

The automatic air conditioning system uses driver, front passenger and rear passenger* independent temperature control to enhance comfort.

*: Models with 3-zone control



SPECIFICATION


a.

Ventilation and Heater Core

*1: Models with dual air layer type air conditioning unit

*2: Models with single air layer type air conditioning unit

Heater Radiator Unit Sub-assembly Type Straight Flow Aluminum (SFA) - II
Size (W x H x L) mm (in.) 263.9 x 120 x 27
(10.4 x 4.7 x 1.1)
Blower with Fan Motor Sub-assembly*1 Motor Type DC Ferrite Brushless
Fan Type Semi Sirocco
Fan Size (Dia. x H) mm (in.) Upper Side: 122.0 x 55.0 (4.8 x 2.2)
Lower Side: 125.0 x 38.0 (4.9 x 1.5)
Blower with Fan Motor Sub-assembly*2 Motor Type DC Ferrite Brushless
Fan Type Semi Sirocco
Fan Size (Dia. x H) mm (in.) 137.0 x 70.0 (5.4 x 2.8)


b.

Air Conditioning

*1: Except models for middle east and destination package for South Korea

*2: Models for middle east and destination package for South Korea

*3: Models with using HFC-134a refrigerant

*4: Models with using HFO-1234yf refrigerant

Cooler Condenser Assembly Type Global Inner-fin Condenser (GIC)
Size (W x H x L) mm (in.) 700 x 453 x 11.5
(27.6 x 17.8 x 0.5)
Fin Pitch mm (in.) 3.0 (0.12)
Compressor with Motor Assembly ESB27
Refrigerant Type HFC-134a*3
HFO-1234yf*4
Evaporator Type Ejector Cycle System (ECS) Evaporator*1
Beneficial Refrigerant Stream (BRS) Evaporator*2
Size (W x H x L) mm (in.) 279.7 x 231.0 x 38.0 (11.0 x 9.1 x 1.5)
Fin Pitch mm (in.) 3.0 (0.12)



MAIN FEATURES


a.

The air conditioning system has the following features:

*1: Except models for middle east and destination package for South Korea

*2: Models for middle east and destination package for South Korea

High Performance
·

A high efficiency type clean air filter, which has a pollen-and-odor removal effect, is used.

·

The rear outlets are installed on the back of the center console to ensure comfortable cooling performance for the rear passengers.

·

The blower control has 7 levels in manual mode and 31 levels in auto mode for more precise control.


Lightweight
·

An air conditioning harness assembly with a built-in communication/driver IC is used in a lightweight wire harness design to allow a reduced number of wires.

·

The use of this type of connector means that pulse pattern type servo motors can be used.


Compact A blower motor with a built-in blower motor controller is used to achieve a compact construction.
Others The following parts are used to ensure high cooling performance while realizing a compact and lightweight construction.
·

Semi-center Location Air Conditioning Unit

·

Ejector Cycle System (ECS) Evaporator*1

·

Beneficial Refrigerant stream (BRS) Evaporator*2

·

Straight Flow Aluminum (SFA)-II Heater Radiator Sub-assembly

·

Global Inner-fin Condenser (GIC) Sub-cool Condenser





PRECAUTION


a.

Precaution for Refrigerant HFO-1234yf (R1234yf)

i.

Compatibility

1.

The parts used in the refrigerant cycle, the compressor oil, etc. of the HFO-1234yf (R1234yf) system are not compatible with the conventional HFC-134a (R134a) system.

2.

Always use HFO-1234yf (R1234yf) as the refrigerant.


CAUTION:
·

Do not charge the system with refrigerant near open flames, as HFO-1234yf (R1234yf) is combustible.

·

When charging the system with refrigerant, make sure the area is well ventilated (especially be careful in areas where the gas can easily accumulate such as under lifts and in garage pits, as the gas is heavier than air).

·

Follow any local regulations regarding combustible gases.

·

Be sure to use a refrigerant recovery unit that is compatible with HFO-1234yf (R1234yf) systems.

·

High pressure gas is used for the air conditioning system. Be sure to follow the procedure describad in the repair manual.



HINT:

The shape of the service port for refrigerant charging has an exclusive design conforming to international standards for HFO-1234yf (R1234yf) to prevent improper refrigerant charging.



ii.

Compressor Oil

1.

Always use ND-OIL 11 as the compressor oil.

2.

When parts of the air conditioning system are removed, quickly block off any areas that are exposed to the outside air with plugs, vinyl tape, etc., as the oil used for HFO-1234yf (R1234yf) systems absorbs moisture easily.

3.

Do not allow the compressor oil to spray, as the oil used for HFO-1234yf (R1234yf) systems has harmful effects on acrylic resins.



iii.

Caution Label

1.

Please confirm the vehicle caution label for the symbol marks used for the vehicle.

Symbol Name Symbol
Caution
Y248270

Air Conditioning System
Y248271

Air Conditioning System Lubricant Type
Y248272

Requires Registered Technician to Service Air Conditioning System
Y248273

Flammable Refrigerant
Y248274