Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › BRAKE HOLD SWITCH
RM33C0E _54 Brake _065442 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0319345 BRAKE HOLD SWITCH G

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  BRAKE HOLD SWITCH  INSPECTION  


PROCEDURE

Hide 84390B 1.INSPECT BRAKE HOLD SWITCH (ELECTRIC PARKING BRAKE SWITCH ASSEMBLY)

a.
C307484C45
2.26,1.177 2.135,0.552 true 2.042,1.844 2.26,1.417 true 1.24,1.188 1.115,0.563 true 0.865,1.823 1.177,1.427 true 0.104,0.094 0.417,0.292 0.313,0.198 10 false *a 1.958,0.375 2.708,0.594 0.75,0.219 10 false +B (*B) 1.823,1.875 2.573,2.115 0.75,0.24 10 false GND1 (*B) 0.917,0.375 1.604,0.594 0.688,0.219 10 false +B (*A) 0.594,1.875 1.333,2.115 0.74,0.24 10 false GND1 (*A)
*A for LHD
*B for RHD
*a Component without harness connected
(Brake Hold Switch (Electric Parking Brake Switch Assembly))


Make sure that there is no looseness in the locking part and the connecting part of the connector.


b.

Disconnect the brake hold switch (electric parking brake switch assembly) connector.


c.

Check both the connector case and the terminal for deformation and corrosion.

OK:

No deformation or corrosion.



d.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
for LHD
Tester Connection Condition Specified Condition
8 (+B) - 16 (GND1) Switch pushed Below 1 Ω
8 (+B) - 16 (GND1) Switch not pushed 10 kΩ or higher

for RHD
Tester Connection Condition Specified Condition
1 (+B) - 9 (GND1) Switch pushed Below 1 Ω
1 (+B) - 9 (GND1) Switch not pushed 10 kΩ or higher


If the result is not as specified, replace the brake hold switch (electric parking brake switch assembly).