| *A | for Type A |
| *B | for Type B |
| *a | Tube |
Do not disconnect the tube shown in the illustration when disassembling the fuel suction tube with pump and gauge assembly. Doing so will cause reassembly of the fuel suction tube with pump and gauge assembly to be impossible as the tube is pressed into the fuel suction plate sub-assembly.
83320
1.REMOVE FUEL SENDER GAUGE ASSEMBLY
23221
2.REMOVE FUEL PUMP
for Type A:
|
Harness Protector |
|
Fuel Pump Harness Connector |
Disengage the 2 clamps to disconnect the fuel pump harness from the fuel suction plate sub-assembly.
Do not damage the wire harness.
When disengaging each wire harness from the clamp, disengage one wire at a time.
Remove the harness protector from the wire harness.
Disconnect the 2 fuel pump harness connectors.
| *1 | Fuel Suction Plate Sub-assembly |
|
Pull |
|
Slide |
Disengage the claw and slide the fuel suction plate sub-assembly and then separate it from the fuel sub-tank sub-assembly.
Disengage the 4 claws and remove the fuel suction plate sub-assembly from the fuel sub-tank sub-assembly.
Disengage the claw and clamp, and disconnect the fuel pump harness.
Disconnect the fuel pump harness connector.
| *a | Fuel Tube Supporter |
Disengage the 3 claws and remove the No. 2 fuel suction support from the fuel tube supporter.
Remove the fuel pump from the fuel tube supporter.
| *1 | O-ring |
| *2 | Fuel Pump Spacer |
Remove the O-ring and fuel pump spacer from the fuel pump.
for Type B:
|
Harness Protector |
|
Fuel Pump Harness Connector |
Disengage the 2 clamps to disconnect the fuel pump harness from the fuel suction plate sub-assembly.
Do not damage the wire harness.
When disengaging each wire harness from the clamp, disengage one wire at a time.
Remove the harness protector from the wire harness.
Disconnect the 2 fuel pump harness connectors.
| *1 | Fuel Suction Plate Sub-assembly |
|
Pull |
|
Slide |
Disengage the claw and slide the fuel suction plate sub-assembly and then separate it from the fuel sub-tank sub-assembly.
Disengage the 4 claws and remove the fuel suction plate sub-assembly from the fuel sub-tank sub-assembly.
Disengage the claw and disconnect the fuel pump harness.
Disconnect the fuel pump harness connector.
| *a | Fuel Tube Supporter |
Disengage the 3 claws and remove the No. 2 fuel suction support from the fuel tube supporter.
Remove the fuel pump from the fuel tube supporter.
| *1 | O-ring |
| *2 | Fuel Pump Spacer |
Remove the O-ring and fuel pump spacer from the fuel pump.