The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel tank assembly removal/installation are shown below.
Never perform work on fuel system components near any possible ignition sources.
Vaporized fuel could ignite, resulting in a serious accident.
Do not perform work on fuel system components without first disconnecting the cable from the negative (-) auxiliary battery terminal.
Sparks could cause vaporized fuel to ignite, resulting in a serious accident.
The fuel tank assembly is very heavy. Be sure to follow the procedure described in the repair manual, or the fuel tank assembly may fall off the engine lifter.
77020A
1.REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY
2.DRAIN FUEL
17420
3.REMOVE CENTER EXHAUST PIPE ASSEMBLY
58399D
4.REMOVE NO. 2 FLOOR UNDER COVER (w/ Cover)
77641A
5.REMOVE NO. 1 FUEL TANK PROTECTOR
Remove the 3 clips and No. 1 fuel tank protector from the fuel tank assembly.
77209F
6.DISCONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY
Disconnect the fuel tank main tube sub-assembly from the fuel pipe.
Click hereEngine / Hybrid System>A25A-FXS (FUEL)>FUEL SYSTEM>PRECAUTION
77754B
7.DISCONNECT CHARCOAL CANISTER OUTLET HOSE
Disconnect the charcoal canister outlet hose from the fuel tank filler pipe assembly.
8.DISCONNECT FUEL TANK BREATHER TUBE SUB-ASSEMBLY
Loosen the clamp, then disconnect the fuel tank breather tube sub-assembly from the fuel tank filler pipe assembly.
77213E
9.DISCONNECT FUEL TANK TO FILLER PIPE HOSE
Loosen the clamp, then disconnect the fuel tank to filler pipe hose from the fuel tank assembly.
77100
10.REMOVE FUEL TANK ASSEMBLY
The fuel tank assembly is very heavy. Be sure to follow the procedure described in the repair manual, or the fuel tank assembly may fall off the engine lifter.
Support the fuel tank assembly using an engine lifter.
Using height adjustment attachments and plate lift attachments, keep the fuel tank assembly horizontal.
Remove the 4 bolts, No. 1 fuel tank band sub-assembly LH and No. 1 fuel tank band sub-assembly RH.
Lower the engine lifter to remove the fuel tank assembly.
Be careful not to drop the fuel tank assembly.
When removing the fuel tank assembly, tilt it slightly to prevent it from interfering with the surrounding parts.
77209F
11.REMOVE FUEL TANK MAIN TUBE SUB-ASSEMBLY
Disengage the 2 clamps to remove the fuel tank main tube sub-assembly from the fuel tank assembly.
77754B
12.REMOVE CHARCOAL CANISTER OUTLET HOSE
Disengage the clamp to remove the charcoal canister outlet hose from the fuel tank assembly.
77651A
13.REMOVE NO. 1 FUEL TANK CUSHION
Remove the 2 No. 1 fuel tank cushions from the fuel tank assembly.