Home › Engine / Hybrid System › A25A-FXS (FUEL) › FUEL SENDER GAUGE ASSEMBLY (w/o Canister Pump Module)
RM33C0E _51 Engine / Hybrid System _065421 A25A-FXS FUEL _0319779 FUEL SENDER GAUGE ASSEMBLY(w/o Canister Pump Module) A

A25A-FXS FUEL  FUEL SENDER GAUGE ASSEMBLY(w/o Canister Pump Module)  INSTALLATION  


PROCEDURE

Hide 83320 1.INSTALL FUEL SENDER GAUGE ASSEMBLY

a.

for Type A:

i.

Engage the claw to install the fuel sender gauge assembly to the fuel suction tube with pump and gauge assembly.

NOTICE:

Be careful not to bend the arm of the fuel sender gauge assembly.



ii.

Engage the 2 clamps to connect the wire harness to the fuel suction tube with pump and gauge assembly.

NOTICE:
·

Do not damage the wire harness.

·

When engaging each wire harness to the clamp, engage one wire at a time.




iii.

Connect the fuel sender gauge assembly connector.



b.

for Type B:

i.

Engage the 2 claws to install the fuel sender gauge assembly to the fuel gauge bracket.


ii.

Engage the 2 claws to install the fuel gauge bracket with fuel sender gauge assembly to the fuel suction tube with pump and gauge assembly.

NOTICE:

Be careful not to bend the arm of the fuel sender gauge assembly.



iii.

Engage the 2 clamps to connect the wire harness to the fuel suction tube with pump and gauge assembly.

NOTICE:
·

Do not damage the wire harness.

·

When engaging each wire harness to the clamp, engage one wire at a time.




iv.

Connect the fuel sender gauge assembly connector.



Hide 77020A 2.INSTALL FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY