Home › Engine / Hybrid System › A25A-FXS (FUEL) › FUEL MAIN VALVE (w/o Canister Pump Module)
RM33C0E _51 Engine / Hybrid System _065421 A25A-FXS FUEL _0319781 FUEL MAIN VALVE(w/o Canister Pump Module) A

A25A-FXS FUEL  FUEL MAIN VALVE(w/o Canister Pump Module)  INSTALLATION  


PROCEDURE

Hide 23070 1.INSTALL FUEL MAIN VALVE ASSEMBLY

a.

for Type A:

i.

Apply gasoline to 2 new O-rings. Then install the O-rings to the fuel main valve assembly.


ii.

Install the fuel main valve assembly to the fuel suction tube with pump and gauge assembly.

NOTICE:

Make sure that the O-rings are not cut or pinched during installation.



iii.

Install the clip to the fuel suction tube with pump and gauge assembly.



b.

for Type B:

i.

Apply gasoline to a new O-ring. Then install the O-ring to the fuel main valve assembly.

NOTICE:
A406613C01
0.844,0.615 0.979,0.615 0.979,0.615 1.208,0.833 false 0.833,1.719 0.969,1.719 0.969,1.719 1.135,1.385 false 1.75,0.729 1.833,0.365 1.833,0.365 1.948,0.365 false 2.01,0.292 2.323,0.448 0.313,0.156 10 false *1 0.677,0.521 0.99,0.677 0.313,0.156 10 false *a 0.667,1.625 0.979,1.781 0.313,0.156 10 false *b 1.198,0.24 1.51,0.396 0.313,0.156 10 false *c
*1 Fuel Main Valve Assembly
*a Mesh
*b Mini-clip
*c No Clearance


Make sure that there is no clearance between the fuel main valve assembly and mesh.



ii.

Install the fuel main valve assembly to the fuel suction tube with pump and gauge assembly.

NOTICE:

Make sure that the O-ring is not cut or pinched during installation.



iii.

Engage the 2 claws to install the fuel pressure regulator holder to the fuel suction tube with pump and gauge assembly.



Hide 77020A 2.INSTALL FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY