Home › General › SPECIFICATIONS › A25A-FXS FUEL
RM33C0E _V1 General _065431 SPECIFICATIONS _0319253 A25A-FXS FUEL F

SPECIFICATIONS  A25A-FXS FUEL  SERVICE DATA  


Fuel pressure Standard fuel pressure 294 to 833 kPa (3.0 to 8.5 kgf/cm2, 43 to 121 psi)
Standard fuel pressure (high pressure side) 3000 to 25000 kPag at 2500 rpm (shift lever in P, engine warmed up and A/C off)
Fuel pressure: for 5 minutes after engine has stopped Standard fuel pressure 98 kPa (1.0 kgf/cm2, 14.2 psi) or more
Port fuel injector assembly Standard resistance 11.6 to 12.4 Ω at 20°C (68°F)
Standard injection volume 67 to 82 cc (4.1 to 5.0 cu.in.) per 15 seconds
Difference between each fuel injector assembly 15 cc (0.9 cu.in.) or less
Standard fuel drop 1 drop or less per 20 minutes
Direct fuel injector assembly Standard resistance 1.34 to 1.64 Ω at 20°C (68°F)
Fuel pressure sensor Standard voltage 2 (PFL) - 3 (E2) Approximately 0.57 to 0.95 V
Fuel pressure sensor (for High Pressure) Standard voltage 3 (PR) - 2 (E2) Approximately 0.4 to 0.6 V
Fuel pump Standard resistance U - V 0.05 to 3.0 Ω
V - W 0.05 to 3.0 Ω
U - W 0.05 to 3.0 Ω
Fuel pump assembly Standard resistance 0.45 to 0.55 Ω at 20°C (68°F)
Fuel sender gauge assembly Standard voltage 4.255 to 4.605 V (Float level F)
0.345 to 4.605 V (Float level F to E)
0.345 to 0.695 V (Float level E)