Home › Engine / Hybrid System › A25A-FXS (EMISSION CONTROL) › CANISTER (w/ Canister Pump Module)
RM33C0E _51 Engine / Hybrid System _065422 A25A-FXS EMISSION CONTROL _0322967 CANISTER(w/ Canister Pump Module) A

A25A-FXS EMISSION CONTROL  CANISTER(w/ Canister Pump Module)  INSTALLATION  


PROCEDURE

Hide 77740R 1.INSTALL LEAK DETECTION PUMP SUB-ASSEMBLY

HINT:

Only perform this procedure when replacement of the leak detection pump sub-assembly is necessary.


a.
A405792

Engage the 2 claws to install a new leak detection pump sub-assembly to the charcoal canister sub-assembly.

NOTICE:
·

Do not allow foreign matter such as grease, oil or water to adhere to the O-ring.

·

Ensure that the claws are engaged properly.




Hide 77740 2.INSTALL CANISTER (CHARCOAL CANISTER ASSEMBLY)

a.

Install the clip to the vehicle body.


b.
A405793

Engage the claw to install the canister (charcoal canister assembly) to the vehicle body as shown in the illustration.


c.

Engage the clip to connect the canister (charcoal canister assembly).


d.

Install the 2 bolts.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


e.

Connect the purge line hose to the canister (charcoal canister assembly) and slide the clip to secure it.


f.
A405795C01
1.896,2.729 2.25,2.729 true 2.25,2.635 2.438,2.833 0.188,0.198 10 false *a
*a Retainer
V100135

Push in


Push the fuel tank vent hose onto the canister (charcoal canister assembly) and push in the retainer to engage the lock claws.

NOTICE:
·

Check that there are no scratches or foreign matter around the connecting parts of the tube connector and pipe (canister (charcoal canister assembly)) before performing this work.

·

After connecting the fuel tank vent hose, check that the fuel tank vent hose is securely connected by pulling on the tube connector.




g.

Connect the leak detection pump sub-assembly connector.


h.

Push in the fuel tank vent hose sub-assembly to the pipe (leak detection pump sub-assembly) until the fuel tank vent hose sub-assembly makes a "click" sound.

NOTICE:
·

Check that there are no scratches or foreign matter around the connecting parts of the tube connector and pipe (leak detection pump sub-assembly) before performing this work.

·

After connecting the fuel tank vent hose sub-assembly, check that the fuel tank vent hose sub-assembly is securely connected by pulling on the tube connector.




Hide 48832A 3.INSTALL REAR NO. 1 STABILIZER BAR BRACKET

a.

Install the 2 rear No. 1 stabilizer bar brackets to the vehicle body with the 4 bolts.

Torque:
78 N*m (795 kgf*cm, 58 ft.*lbf)