Home › Engine / Hybrid System › A25A-FXS (EMISSION CONTROL) › VACUUM SENSOR
RM33C0E _51 Engine / Hybrid System _065422 A25A-FXS EMISSION CONTROL _0322975 VACUUM SENSOR A

A25A-FXS EMISSION CONTROL  VACUUM SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:

This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 89421 1.INSTALL E.F.I. VACUUM SENSOR ASSEMBLY (MANIFOLD ABSOLUTE PRESSURE SENSOR)

a.

Using an 8 mm socket wrench, install the E.F.I. vacuum sensor assembly (manifold absolute pressure sensor) to the intake manifold with the bolt.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


b.

Connect the vacuum hose to the E.F.I. vacuum sensor assembly (manifold absolute pressure sensor).


c.

Connect the E.F.I. vacuum sensor assembly (manifold absolute pressure sensor) connector.