This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
11301C
1.INSTALL TIMING CHAIN COVER OIL SEAL
Apply MP grease to the lip of a new timing chain cover oil seal.
Keep the lip free from foreign matter.
Do not allow MP grease to contact the dust seal.
| *a | 0 to 2 mm |
Using SST and a hammer, tap in the timing chain cover oil seal.
0 to 2 mm (0 to 0.0787 in.) (From the edge of the No. 2 timing gear cover assembly)
Do not tap in the timing chain cover oil seal at an angle.
13470
2.INSTALL CRANKSHAFT PULLEY ASSEMBLY
3.INSTALL ENGINE ASSEMBLY WITH TRANSAXLE