89668
1.INSTALL NO. 2 ECM BRACKET
Install the No. 2 ECM bracket to the ECM with the 2 screws.
89667E
2.INSTALL NO. 1 ECM BRACKET
Install the No. 1 ECM bracket to the ECM with the 2 screws.
89661
3.INSTALL ECM
for LHD:
Install the ECM with the 2 nuts in the order shown in the illustration.
If the ECM has been struck or dropped, replace it.
Engage the clamp.
Install the engine wire to the No. 2 ECM bracket with the bolt.
Connect the 2 ECM connectors and rotate the 2 levers to lock them.
When connecting the ECM connectors, make sure that the connecting parts of the ECM connectors are free of dirt, water and other foreign matter.
Be sure to securely connect the ECM connectors.
for RHD:
Install the ECM with the 2 nuts in the order shown in the illustration.
If the ECM has been struck or dropped, replace it.
Engage the 2 clamps.
Install the engine wire to the No. 2 ECM bracket with the bolt.
Connect the 2 ECM connectors and rotate the 2 levers to lock them.
When connecting the ECM connectors, make sure that the connecting parts of the ECM connectors are free of dirt, water and other foreign matter.
Be sure to securely connect the ECM connectors.
4.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
64718C
5.INSTALL LUGGAGE TRIM SERVICE HOLE COVER
6.PERFORM INITIALIZATION
w/ Canister Pump Module: Click hereEngine / Hybrid System>A25A-FXS (ENGINE CONTROL)>SFI SYSTEM (w/ Canister Pump Module)>PRECAUTION
w/o Canister Pump Module: Click hereEngine / Hybrid System>A25A-FXS (ENGINE CONTROL)>SFI SYSTEM (w/o Canister Pump Module)>PRECAUTION