Home › Engine / Hybrid System › A25A-FXS (ENGINE CONTROL) › CRANKSHAFT POSITION SENSOR
RM33C0E _51 Engine / Hybrid System _065419 A25A-FXS ENGINE CONTROL _0326948 CRANKSHAFT POSITION SENSOR A

A25A-FXS ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 53295E 1.REMOVE COOL AIR INTAKE DUCT SEAL

Hide 17750A 2.REMOVE INLET AIR CLEANER ASSEMBLY

Hide 11401G 3.REMOVE CRANKSHAFT POSITION SENSOR

a.
A406036

Disconnect the crankshaft position sensor connector.


b.

Using an 8 mm socket wrench, remove the bolt and crankshaft position sensor from the cylinder block sub-assembly.

NOTICE:

If the crankshaft position sensor has been struck or dropped, replace it.