Home › Engine / Hybrid System › A25A-FXS (ENGINE CONTROL) › ENGINE OIL TEMPERATURE SENSOR › 2017.09–2019.10
RM33C0E _51 Engine / Hybrid System _065419 A25A-FXS ENGINE CONTROL _0326951 ENGINE OIL TEMPERATURE SENSOR A

A25A-FXS ENGINE CONTROL  ENGINE OIL TEMPERATURE SENSOR  INSTALLATION  


PROCEDURE

Hide 89429F 1.INSTALL ENGINE OIL TEMPERATURE SENSOR

a.

Install a new gasket to the engine oil temperature sensor.


b.
A402376N01
2.042,1.469 2.469,1.469 true 2.479,1.375 2.938,1.573 0.458,0.198 10 true SST

Using SST, install the engine oil temperature sensor to the cylinder block sub-assembly.

SST
09817-33191  

Torque:
19.6 N*m (200 kgf*cm, 14 ft.*lbf)

NOTICE:

If the engine oil temperature sensor has been struck or dropped, replace it.



c.

Connect the engine oil temperature sensor connector.


Hide 3.INSPECT FOR ENGINE OIL LEAK

Hide 4.INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY (w/ Cover)

Hide 51441 5.INSTALL NO. 1 ENGINE UNDER COVER (w/ Cover)

Hide 53852K 6.INSTALL FRONT WHEEL OPENING EXTENSION PAD LH (w/ Cover)

Hide 53851M 7.INSTALL FRONT WHEEL OPENING EXTENSION PAD RH (w/ Cover)