Home › Vehicle Exterior › SLIDING ROOF / CONVERTIBLE › SLIDING ROOF HOUSING(for Moon Roof) › 2017.09–2019.02
RM33C0E _59 Vehicle Exterior _065468 SLIDING ROOF / CONVERTIBLE _0328287 SLIDING ROOF HOUSING(for Moon Roof) A

SLIDING ROOF / CONVERTIBLE  SLIDING ROOF HOUSING(for Moon Roof)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during sliding roof housing removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
·

Sliding roof ECU (sliding roof drive gear sub-assembly)

·

Sliding roof glass sub-assembly

·

Sliding roof drive cable sub-assembly

·

Sliding roof drive gear sub-assembly


Initialize Sliding Roof System
·

Auto operation function

·

Jam protection function

·

Key-off operation function

·

Key-linked function

·

Wireless transmitter-linked function

·

Sliding roof open warning function


(Click here)
Disconnect cable from negative (-) auxiliary battery terminal Perform steering sensor zero point calibration Lane Departure Alert System (w/ Steering Control) (Click here)
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)

CAUTION:
B394719

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


PROCEDURE

Hide 63218G 1.REMOVE SLIDING ROOF SIDE GARNISH LH

a.
B468943

Disengage the 4 claws to remove the sliding roof side garnish LH.


Hide 63217G 2.REMOVE SLIDING ROOF SIDE GARNISH RH

HINT:

Use the same procedure as for the LH side.


Hide 63201G 3.REMOVE SLIDING ROOF GLASS SUB-ASSEMBLY

a.

Move the sliding roof glass sub-assembly to the fully closed position.


b.

Using a T25 "TORX" socket wrench, remove the 4 screws and sliding roof glass sub-assembly.

B468944

NOTICE:

To prevent the sliding roof glass sub-assembly and sliding roof drive gear sub-assembly from becoming misaligned, move the sliding roof glass sub-assembly (sliding roof drive cable sub-assembly) to the fully closed position before removing it.



Hide 63251H 4.REMOVE SLIDING ROOF WEATHERSTRIP

a.
B422585

Remove the sliding roof weatherstrip from the sliding roof panel sub-assembly.


Hide 62180A 5.REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH

Hide 62170A 6.REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.


Hide 7.DISCONNECT SLIDING ROOF DRAIN HOSE

HINT:

Use the same procedure for all of the sliding roof drain hoses.


a.
B468945

for Clamp Type:

i.

Disengage the claw and disconnect the sliding roof drain hose.



b.
B468946

for Clip Type:

i.

Expand the clip and disconnect the sliding roof drain hose.



Hide 8.REMOVE SLIDING ROOF HOUSING ASSEMBLY

a.

Remove the 8 bolts, 6 nuts and sliding roof housing assembly.

B468947