The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during grille shutter removal/installation are shown below.
1.REMOVE FRONT BUMPER ASSEMBLY
16691A
2.REMOVE FRONT RADIATOR SIDE AIR GUIDE PLATE RH (for Type A)
Disengage the 2 claws to remove the front radiator side air guide plate RH.
16691A
3.REMOVE FRONT RADIATOR SIDE AIR GUIDE PLATE RH (for Type B)
Disengage the 2 claws to remove the front radiator side air guide plate RH.
16695A
4.REMOVE FRONT RADIATOR SIDE AIR GUIDE PLATE LH (for Type A)
Disengage the 2 claws to remove the front radiator side air guide plate LH.
16695A
5.REMOVE FRONT RADIATOR SIDE AIR GUIDE PLATE LH (for Type B)
Disengage the 2 claws to remove the front radiator side air guide plate LH.
88790B
6.REMOVE THERMISTOR ASSEMBLY
53019F
7.REMOVE RADIATOR SHUTTER SUB-ASSEMBLY (for Type A)
Disconnect the connector.
Disengage the clamp.
Remove the 3 bolts.
|
Remove in this Direction |
Disengage the 2 guides to remove the radiator shutter sub-assembly as shown in the illustration.
53019F
8.REMOVE RADIATOR SHUTTER SUB-ASSEMBLY (for Type B)
Disconnect the connector.
Remove the 3 bolts.
|
Remove in this Direction |
Disengage the 2 guides to remove the radiator shutter sub-assembly as shown in the illustration.