If the skid control ECU (brake booster with master cylinder assembly) determines that the vehicle is being driven at a steep bank angle, the skid control ECU (brake booster with master cylinder assembly) stores DTC C1440 while VSC operation is temporarily disabled.
This is not a malfunction if the system and sensor circuits are normal and normal VSC operation resumes.
| DTC No. | Detection Item | INF Code | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|---|
| C1440 | Steering Angle Sensor Unusual Bank Angle Detected | 1157 | Driving at a steep bank angle. | Yaw rate sensor (airbag sensor assembly) | VSC DTC |
Clear the DTCs.
Turn the power switch off.
Turn the power switch on (READY).
Perform a road test.
Check if the same DTC is output.
| Result | Proceed to |
|---|---|
| DTC C1440 is output. | A |
| Yaw rate and acceleration sensor DTCs are output. | B |
| DTC C1440 is not output. | C |
A
B
C
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT