Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › 2017.09–2021.02
RM33C0E _51 Engine / Hybrid System _065434 CRUISE CONTROL _0328967 DYNAMIC RADAR CRUISE CONTROL SYSTEM C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  P157800  Brake System  


DESCRIPTION

This DTC is stored when a malfunction is detected in the electronically controlled brake system.

DTC No. Detection Item DTC Detection Condition Trouble Area
P157800 Brake System While the power switch is on (IG) and the dynamic radar cruise control system is operating, a malfunction in the electronically controlled brake system is detected for 0.2 seconds or more.
·

Electronically controlled brake system

·

Hybrid vehicle control ECU assembly



CAUTION / NOTICE / HINT

NOTICE:
·

First check the CAN communication system by following How to Proceed with Troubleshooting. After checking that there are no malfunctions in the CAN communication system, proceed with troubleshooting.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING

·

Before replacing the hybrid vehicle control ECU assembly, refer to Service Bulletin.



PROCEDURE

1.CHECK FOR DTCs (ELECTRONICALLY CONTROLLED BRAKE SYSTEM)
a.

Check for DTCs.

Chassis > ABS/VSC/TRC > Trouble Codes
50001 105

Result:
Result Proceed to
DTCs are not output A
DTCs are output B



A

2.CHECK FOR DTCs (RADAR CRUISE 1)

B

2.CHECK FOR DTCs (RADAR CRUISE 1)
a.

Clear the DTCs.

Powertrain > Cruise Control > Clear DTCs
50002 399

b.

Perform the following procedure.

HINT:

If the following procedure is not performed, the previously output DTC cannot be detected.

1.

Turn the power switch on (IG).

2.

Turn the dynamic radar cruise control system on using the cruise control main switch.

3.

Wait for 1 second or more.




c.

Check for DTCs.

Powertrain > Cruise Control > Trouble Codes
50001 399

Result:
Result Proceed to
DTC P157800 is not output A
DTC P157800 is output B



A

B