Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › 2017.09–2021.02
RM33C0E _51 Engine / Hybrid System _065434 CRUISE CONTROL _0328967 DYNAMIC RADAR CRUISE CONTROL SYSTEM J

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  Cruise Main Indicator Light Circuit  


DESCRIPTION

When the dynamic radar cruise control system is turned on using the cruise control main switch, the cruise control indicator (vehicle-to-vehicle distance control mode) illuminates. The hybrid vehicle control ECU assembly uses this and other indicators to indicate the control condition (presence or absence of a preceding vehicle, vehicle-to-vehicle distance, and set vehicle speed) and fail-safe state via CAN communication.

CAUTION / NOTICE / HINT

NOTICE:

Before replacing the hybrid vehicle control ECU assembly, refer to Service Bulletin.


PROCEDURE

1.PERFORM ACTIVE TEST USING GTS
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Combination Meter / Active Test.


e.

Perform the Active Test according to the display on the GTS.

Body Electrical > Combination Meter > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Multi Display All (White) Multi-information display (White display) ON -
Body Electrical > Combination Meter > Active Test
Tester Display
Multi Display All (White)
50004 409 20

Result:
Result Proceed to
The multi-information display in the combination meter assembly turns on according to the operation of the Active Test. A
The multi-information display in the combination meter assembly does not turn on according to the operation of the Active Test. B



A

2.READ VALUE USING GTS

B

2.READ VALUE USING GTS
a.

Enter the following menus: Powertrain / Radar Cruise 1 / Data List.


b.

Read the Data List according to the display on the GTS.

Powertrain > Cruise Control > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Cruise Ready Main-CPU Cruise control system standby condition ON or OFF ON: Cruise control main switch pushed
OFF: Cruise control main switch not pushed
-
Cruise Ready Sub-CPU Cruise control system standby condition ON or OFF ON: Cruise control main switch pushed
OFF: Cruise control main switch not pushed
-
Cruise Indicator Cruise control indicator status ON or OFF ON: Cruise control indicator illuminates
OFF: Cruise control indicator turns off
-
Powertrain > Cruise Control > Data List
Tester Display
Cruise Ready Main-CPU
Cruise Ready Sub-CPU
Cruise Indicator
50003 399 25,24,20

Result:
Result Proceed to
The cruise control indicator illuminates and turns off according to the operation of the cruise control main switch. A
The cruise control indicator does not illuminate but the Data List items change according to the operation of the cruise control main switch. B
The cruise control indicator does not illuminate and the Data List items do not change according to the operation of the cruise control main switch. C



A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

B

REPLACE COMBINATION METER ASSEMBLY

C