73350C
1.DISCONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY
for Fold Down Seat Type:
Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY (for Fold Down Seat Type)>REMOVAL
for Reclining Seat Type:
Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY (for Reclining Seat Type)>REMOVAL
2.REMOVE REAR SEAT CUSHION ASSEMBLY
for Fold Down Seat Type:
Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY (for Fold Down Seat Type)>REMOVAL
for Reclining Seat Type:
Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY (for Reclining Seat Type)>REMOVAL
72693
3.REMOVE REAR SEAT CUSHION LOCK HOOK
for Fold Down Seat Type:
Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY (for Fold Down Seat Type)>REMOVAL
for Reclining Seat Type:
Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY (for Reclining Seat Type)>REMOVAL
67918A
4.REMOVE REAR DOOR SCUFF PLATE LH
76974F
5.REMOVE REAR UNDER SIDE COVER LH
| *a | Clip (A) |
| *b | Clip (B) |
| *c | Clip (C) |
Remove the 2 clips (A).
Disengage the claw, 3 clips (B), 2 clips (C) and guide to remove the rear under side cover LH.
67917A
6.REMOVE REAR DOOR SCUFF PLATE RH
Use the same procedure as for the LH side.
76973F
7.REMOVE REAR UNDER SIDE COVER RH
| *a | Clip (A) |
| *b | Clip (B) |
| *c | Clip (C) |
Remove the 2 clips (A).
Disengage the claw, 3 clips (B), 2 clips (C) and guide to remove the rear under side cover RH.
76971G
8.REMOVE REAR UNDER COVER
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Pull the rear under cover in the direction indicated by the arrow (1) shown in the illustration to disengage the 2 clips.
Pull the rear under cover in the direction indicated by the arrow (2) shown in the illustration to disengage the 2 guides to remove it from the rear seat cushion leg sub-assembly.
71033
9.REMOVE REAR SEAT CUSHION LEG SUB-ASSEMBLY
Remove the 6 bolts and rear seat cushion leg sub-assembly.
G92D1
10.REMOVE NO. 1 HYBRID BATTERY INTAKE DUCT
Disengage the 2 clamps.
Remove the 2 clips and No. 1 hybrid battery intake duct from the battery cooling blower assembly.
G9230
11.REMOVE BATTERY COOLING BLOWER ASSEMBLY
Disconnect the battery cooling blower assembly connector.
Remove the bolt, nut and battery cooling blower assembly from the HV battery.
Be sure not to touch the fan part of the battery cooling blower assembly.
Do not lift the battery cooling blower assembly using the wire harness.
G923B
12.REMOVE BATTERY COOLING BLOWER BRACKET
Disengage the clamp.
Remove the 3 bolts and battery cooling blower bracket from the battery cooling blower assembly.