Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING RECEIVER › 2017.09–2018.04
RM33C0E _53 Suspension _065440 TIRE PRESSURE MONITORING _0329003 TIRE PRESSURE WARNING RECEIVER A

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING RECEIVER  INSTALLATION  


PROCEDURE

Hide 897B0A 1.INSTALL TIRE PRESSURE WARNING ECU AND RECEIVER

NOTICE:
·

Do not drop, strike or otherwise subject the tire pressure warning ECU and receiver to impact.

·

If the tire pressure warning ECU and receiver is subjected to an impact, replace it with a new one.



a.
C374642C01
0.281,0.177 0.594,0.333 0.313,0.156 10 false *A 2.083,0.177 2.396,0.333 0.313,0.156 10 false *B
*A for Type A
*B for Type B


Connect the connector.


b.

Engage the 2 guides and install the tire pressure warning ECU and receiver with the bolt.

Torque:
for Type A : 8.3 N*m (85 kgf*cm, 73 in.*lbf)
for Type B : 10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:

There are three types of bolts and the tightening torque depends on the type of bolt used as shown in the illustration. Therefore, confirm the tightening torque before installing the bolt.



Hide 62471A 2.INSTALL INNER ROOF SIDE GARNISH RH

HINT:

Use the same procedure as for the LH side.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION


Hide 3.INSTALL REAR SIDE SEATBACK ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.

Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY (for Fold Down Seat Type)>INSTALLATION


Hide 62331A 4.INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH

Hide 72693 5.INSTALL REAR SEAT CUSHION LOCK HOOK

Hide 73350C 7.CONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY

Hide 8.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

Hide 64718C 9.INSTALL LUGGAGE TRIM SERVICE HOLE COVER