The hybrid vehicle control ECU assembly receives signals from the skid control ECU (brake booster with master cylinder assembly) via CAN communication.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U012287 | Lost Communication with Vehicle Dynamics Control Module Missing Message | While the power switch is on (IG) and the cruise control system is operating, signals cannot be received from the skid control ECU (brake booster with master cylinder assembly) for 2.65 seconds or more. | ·
CAN communication system ·
Hybrid vehicle control ECU assembly ·
Skid control ECU (brake booster with master cylinder assembly) |
Refer to troubleshooting in CAN Communication System.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Clear the DTCs.
Perform the following procedure.
If the following procedure is not performed, the previously output DTC cannot be detected.
Turn the power switch on (IG).
Turn the cruise control system on using the cruise control main switch.
Wait for 3 seconds or more.
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTC U012287 is not output | A |
| DTC U012287 is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING