This DTC is stored when there is a malfunction in the hybrid vehicle control ECU assembly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| P057504 | Cruise Control System Internal Failure | While the cruise control system is operating, the cruise control system control of vehicle speed is not canceled and approximately 0.4 seconds have elapsed since cruise cancel signal (STP signal) is input to the hybrid vehicle control ECU assembly. | Hybrid vehicle control ECU assembly |
| P057549 | Cruise Control Internal Electronic Failure | When the power switch is on (IG), STP signals input to the hybrid vehicle control ECU assembly supervisory CPU and that input to the control ECU do not match for approximately 0.2 seconds or more. | Hybrid vehicle control ECU assembly |
Before replacing the hybrid vehicle control ECU assembly, refer to Service Bulletin.
The hybrid vehicle control ECU assembly receives signals from each sensor to control all functions of the cruise control system. When a malfunction is detected, the fail-safe function operates until the power switch is turned off.
Clear the DTCs.
Perform the following procedure.
If the following procedure is not performed, the previously output DTC cannot be detected.
Drive the vehicle at a speed for which cruise control operation is possible.
Turn the cruise control system on using the cruise control main switch.
Depress the brake pedal for 1 second or more.
Check for DTCs.
DTC P057504 and P057549 are not output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG