This DTC is stored when a malfunction is detected in the electronically controlled brake system.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| P157800 | Brake System | While the power switch is on (IG) and the cruise control system is operating, a malfunction in the electronically controlled brake system is detected for 0.2 seconds or more. | ·
Electronically controlled brake system ·
Hybrid vehicle control ECU assembly |
Before replacing the hybrid vehicle control ECU assembly, refer to Service Bulletin.
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
A
B
Clear the DTCs.
Perform the following procedure.
If the following procedure is not performed, the previously output DTC cannot be detected.
Turn the power switch on (IG).
Turn the cruise control system on using the cruise control main switch.
Wait for 1 second or more.
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTC P157800 is not output | A |
| DTC P157800 is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B