Home › Brake › PARKING BRAKE › ELECTRIC PARKING BRAKE SYSTEM › 2017.09–2021.02
RM33C0E _54 Brake _065446 PARKING BRAKE _0329402 ELECTRIC PARKING BRAKE SYSTEM C

PARKING BRAKE  ELECTRIC PARKING BRAKE SYSTEM  C1245  Deceleration Sensor  


DESCRIPTION

The parking brake ECU (brake actuator assembly) receives vehicle tilt angle information from the deceleration sensor (airbag sensor assembly) via CAN communication.

DTC No. Detection Item DTC Detection Condition Trouble Area Memory Note
C1245 Deceleration Sensor One of following conditions is met:
1.

An error signal is sent from deceleration sensor (airbag sensor assembly) for approximately 0.3 seconds.

2.

While the deceleration sensor (airbag sensor assembly) signal is judged to be stuck, starting off and stopping of vehicle occurs 16 times.

3.

Comparison error between deceleration sensor (airbag sensor assembly) 1 and deceleration sensor (airbag sensor assembly) 2 output values occurs for 60 seconds or more.


Deceleration sensor (Airbag sensor assembly) DTC stored An electric parking brake system malfunction is displayed on the multi-information display.

DTC Detection Conditions
Vehicle Condition
Pattern 1 Pattern 2 Pattern 3
Diagnosis Condition Power switch on (IG) ○ ○ ○
Malfunction Status An error signal is sent from the deceleration sensor (airbag sensor assembly) ○ - -
While the deceleration sensor (airbag sensor assembly) signal is judged to be stuck, starting off and stopping the vehicle occurs 16 times - ○ -
Comparison error between deceleration sensor (airbag sensor assembly) 1 and deceleration sensor (airbag sensor assembly) 2 output values occurs - - ○
Detection Time Approximately 0.3 seconds - 60 seconds or more
Number of Trips 1 trip 1 trip 1 trip

HINT:

DTC will be output when conditions for either of the patterns in the table above are met.


CAUTION / NOTICE / HINT

NOTICE:

When replacing the deceleration sensor (airbag sensor assembly), perform initialization and calibration of the linear solenoid valve.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>INITIALIZATION


PROCEDURE

1.CHECK DTC (ELECTRONICALLY CONTROLLED BRAKE SYSTEM)
a.

Check for DTCs.

Chassis > ABS/VSC/TRC > Trouble Codes
50001 105
Result:
Result Proceed to
DTC is not output A
DTC is output B




A

2.CHECK DTC (ELECTRIC PARKING BRAKE SYSTEM)

B

2.CHECK DTC (ELECTRIC PARKING BRAKE SYSTEM)
a.

Clear the DTCs.

Chassis > Electric Parking Brake > Clear DTCs
50002 184

b.

Turn the power switch off.


c.

Check for DTCs.

Chassis > Electric Parking Brake > Trouble Codes
50001 184
Result:
Result Proceed to
DTCs are output A
DTCs are not output B




A

B