84390B
1.INSPECT ELECTRIC PARKING BRAKE SWITCH (ELECTRIC PARKING BRAKE SWITCH ASSEMBLY)
Check the resistance.
| *a | Component without harness connected
(Electric Parking Brake Switch Assembly) |
| *a | Component without harness connected
(Electric Parking Brake Switch Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| K37-9 (SWI1) - K37-10 (SWO1) | OFF (Release) | 100 kΩ or higher |
| ON (Lock) | 10 Ω or less | |
| Switch not operated | 100 kΩ or higher | |
| K37-9 (SWI1) - K37-1 (SWI2) | OFF (Release) | 10 Ω or less |
| ON (Lock) | 10 Ω or less | |
| Switch not operated | 100 kΩ or higher | |
| K37-9 (SWI1) - K37-2 (SWO2) | OFF (Release) | 10 Ω or less |
| ON (Lock) | 100 kΩ or higher | |
| Switch not operated | 10 Ω or less | |
| K37-1 (SWI2) - K37-10 (SWO1) | OFF (Release) | 100 kΩ or higher |
| ON (Lock) | 10 Ω or less | |
| Switch not operated | 10 Ω or less | |
| K37-1 (SWI2) - K37-2 (SWO2) | OFF (Release) | 10 Ω or less |
| ON (Lock) | 100 kΩ or higher | |
| Switch not operated | 100 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| K37-16 (SWI1) - K37-15 (SWO1) | OFF (Release) | 100 kΩ or higher |
| ON (Lock) | 10 Ω or less | |
| Switch not operated | 100 kΩ or higher | |
| K37-16 (SWI1) - K37-8 (SWI2) | OFF (Release) | 10 Ω or less |
| ON (Lock) | 10 Ω or less | |
| Switch not operated | 100 kΩ or higher | |
| K37-16 (SWI1) - K37-7 (SWO2) | OFF (Release) | 10 Ω or less |
| ON (Lock) | 100 kΩ or higher | |
| Switch not operated | 10 Ω or less | |
| K37-8 (SWI2) - K37-15 (SWO1) | OFF (Release) | 100 kΩ or higher |
| ON (Lock) | 10 Ω or less | |
| Switch not operated | 10 Ω or less | |
| K37-8 (SWI2) - K37-7 (SWO2) | OFF (Release) | 10 Ω or less |
| ON (Lock) | 100 kΩ or higher | |
| Switch not operated | 100 kΩ or higher |
If the result is not as specified, replace the electric parking brake switch assembly.
Check the Illuminates.
| *a | Component without harness connected
(Electric Parking Brake Switch Assembly) |
| *a | Component without harness connected
(Electric Parking Brake Switch Assembly) |
Apply auxiliary battery voltage to the electric parking brake switch assembly and check that the switch illuminates.
| Condition | Specified Condition |
|---|---|
| Auxiliary battery positive (+) → K37-4 (IND+)
Auxiliary battery negative (-) → K37-5 (IND-) |
Illuminates |
| Condition | Specified Condition |
|---|---|
| Auxiliary battery positive (+) → K37-5 (IND+)
Auxiliary battery negative (-) → K37-4 (IND-) |
Illuminates |
If the result is not as specified, replace the electric parking brake switch assembly.