Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM
RM33C0E _55 Steering _065447 POWER ASSIST SYSTEMS _0329532 POWER STEERING SYSTEM C

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  C1516  Torque Sensor Zero Point Adjustment Incomplete  


DESCRIPTION

This DTC does not indicate a malfunction. The power steering ECU (rack and pinion power steering gear assembly) stores this DTC when it determines that torque sensor zero point calibration has not completed.

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Return-to-normal Condition Note
C1516 Torque Sensor Zero Point Adjustment Incomplete Torque sensor zero point calibration is incomplete due to the steering wheel being touched during calibration. Torque sensor zero point calibration EPS warning light: Comes on The DTC is cleared There is no malfunction if this DTC is not output again after clearing the DTC and torque sensor calibration value, and performing zero point calibration.

CAUTION / NOTICE / HINT

NOTICE:

If the rack and pinion power steering gear assembly has been replaced, perform assist map writing and torque sensor zero point calibration.

Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION


PROCEDURE

1.REPLACE CHECK FOR DTC
a.

Clear the DTCs. (Step 1)

Chassis > EMPS > Clear DTCs
50002 142

b.

Calibrate the torque sensor zero point. (Step 2)

Chassis > EMPS > Utility
Tester Display
Torque Sensor Adjustment
50005 142 224

c.

Check for DTCs. (Step 3)

Chassis > EMPS > Trouble Codes
50001 142
HINT:

If DTCs are output, perform steps (1) to (3) two more times.



Result:
Result Proceed to
DTCs are still output after performing steering zero point calibration 3 times. A
Normal system code is output. B



A

REPLACE RACK AND PINION POWER STEERING GEAR ASSEMBLY

B

END