Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM
RM33C0E _55 Steering _065447 POWER ASSIST SYSTEMS _0329532 POWER STEERING SYSTEM C

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  C1541  Vehicle Speed Signal  


DESCRIPTION

The power steering ECU (rack and pinion power steering gear assembly) receives vehicle speed signals from the skid control ECU (brake booster with master cylinder assembly) via CAN communication. The ECU provides appropriate assist force in accordance with the vehicle speed based on the signals.

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Return-to-normal Condition Note
C1541 Vehicle Speed Signal A vehicle speed signal malfunction is detected
·

Brake control system

·

CAN communication system


EPS warning light: Comes on The ECU judges the system has returned to normal -

CAUTION / NOTICE / HINT

NOTICE:

If the rack and pinion power steering gear assembly has been replaced, perform assist map writing and torque sensor zero point calibration.

Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION


PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
a.

Check if DTC U0129 is output.

Chassis > EMPS > Trouble Codes
50001 142

Result:
Result Proceed to
DTC U0129 is not output. A
DTC U0129 is output. B



A

B

GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)