Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM › 2017.09–2021.02
RM33C0E _53 Suspension _065440 TIRE PRESSURE MONITORING _0329663 TIRE PRESSURE WARNING SYSTEM C

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING SYSTEM  C2176/76  Receiver Error  


DESCRIPTION

Tire pressure warning valve and transmitter signals are transmitted to the tire pressure warning ECU and receiver in the vehicle as radio waves.

DTC No. Detection Item DTC Detection Condition Trouble Area Note
C2176/76 Receiver Error Malfunction in the tire pressure warning ECU and receiver internal circuit Tire pressure warning ECU and receiver -

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the tire pressure warning ECU and receiver, read the transmitter IDs and number of the transmitters (4 or 5) stored in the old ECU using the GTS and write them down before removal.

·

It is necessary to perform initializationSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>INITIALIZATION after registrationSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>REGISTRATION of the transmitter IDs into the tire pressure warning ECU and receiver if the ECU has been replaced.



PROCEDURE

1.CHECK DTC OUTPUT (C2176/76)
a.

Clear the DTCs.

Chassis > Tire Pressure Monitor > Clear DTCs
50002 203

b.

Turn the power switch off.


c.

Turn the power switch on (IG) and check for DTCs.

Chassis > Tire Pressure Monitor > Trouble Codes
50001 203

Result:
Result Proceed to
C2176/76 is not output A
C2176/76 is output B



A

END

B

REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER