This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
89491
1.INSTALL ENGINE OIL LEVEL SENSOR
Using an 8 mm socket wrench, install the engine oil level sensor to the engine balancer assembly with the 2 bolts.
Install a new clip to the engine oil level sensor.
Connect the engine oil level sensor connector.
12102A
2.INSTALL NO. 2 OIL PAN SUB-ASSEMBLY
3.ADD ENGINE OIL
4.INSPECT FOR ENGINE OIL LEAK
5.CHECK ENGINE OIL LEVEL
6.INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY (w/ Cover)
51441
7.INSTALL NO. 1 ENGINE UNDER COVER (w/ Cover)
53852K
8.INSTALL FRONT WHEEL OPENING EXTENSION PAD LH (w/ Cover)
53851M
9.INSTALL FRONT WHEEL OPENING EXTENSION PAD RH (w/ Cover)