CUSTOMIZE METER / GAUGE SYSTEM
When the customer requests a change in a function, first make sure that the function can be customized.
Be sure to make a note of the current settings before customizing.
When troubleshooting a function, first make sure that the function is set to the default setting.
The following items can be customized.
Customizing with the GTS
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Customize Setting / Warning or Display.
Select the setting by referring to the table below.
| Tester Display | Description | Default | Setting | ECU |
|---|---|---|---|---|
| Flasher Sound Volume Adjust | Function to change the flasher sound volume | Medium | $02:Large,$00:Medium,$01:Small | Combination meter assembly |
| Suggestion Service Function | Function to change the suggestion service display setting | ON | 00:OFF,01:Only Parked,11:ON | Main body ECU (Multiplex network body ECU) |
| Tester Display | Description | Default | Setting | ECU |
|---|---|---|---|---|
| ODO Display Time After IG OFF Adjust | Function to change the ODO display time after the power switch is turned off | 30s | $00:30s,$01:60s,$02:600s,$03:OFF | Combination meter assembly |
Customizing with the multi-display
Turn the power switch on (IG).
Enter the following menus: MENU / Setup / Vehicle / Vehicle customisation / Convenience Services.
Select the setting by referring to the table below.
| Display | Default | Content | Setting | Relevant ECU |
|---|---|---|---|---|
| Convenience services | On | Function to change the suggestion service display setting | On, On During, Off | Main body ECU (Multiplex network body ECU) |