Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM
RM33C0E _58 Vehicle Interior _065458 METER / GAUGE / DISPLAY _0330016 METER / GAUGE SYSTEM J

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  Entire Combination Meter does not Operate  


DESCRIPTION

This circuit is the power source circuit for the combination meter assembly. This circuit provides two types of power sources; one is a constant power source, and the other is an IG power source.

WIRING DIAGRAM

E367217E03
0.906,0.719 2.26,0.917 1.354,0.198 10 false from IG2 NO. 2 Relay 0.927,1.375 2.365,1.625 1.438,0.25 10 false from Auxiliary Battery 3.719,1.583 4.823,1.781 1.104,0.198 10 false ECU-DCC NO. 2 3.854,0.885 4.625,1.063 0.771,0.177 10 false METER-IG2 4.969,3.146 6.792,3.365 1.823,0.219 10 false Combination Meter Assembly 5.24,0.615 5.448,0.781 0.208,0.167 10 false 39 5.51,0.708 5.792,0.885 0.281,0.177 10 false IG+ 5.24,1.292 5.448,1.458 0.208,0.167 10 false 40 5.24,1.906 5.448,2.073 0.208,0.167 10 false 21 5.313,2.438 5.521,2.604 0.208,0.167 10 false 2 5.51,1.396 5.677,1.573 0.167,0.177 10 false B 5.51,2.01 5.76,2.208 0.25,0.198 10 false ES 5.5,2.552 5.75,2.75 0.25,0.198 10 false EP 4.979,2.979 5.313,3.156 0.333,0.177 10 false K21

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.

·

Inspect the fuses of circuits related to this system before performing the following procedure.



PROCEDURE

1.CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT)
a.

Disconnect the K21 combination meter assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
K21-21 (ES) - Body ground Always Below 1 Ω
K21-2 (EP) - Body ground Always Below 1 Ω



c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
K21-39 (IG+) - Body ground Power switch off Below 1 V
Power switch on (IG) 11 to 14 V
K21-40 (B) - Body ground Power switch off 11 to 14 V



Result:
Proceed to
OK
NG



OK

REPLACE COMBINATION METER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR