COMBINATION METER ASSEMBLY
Measure the voltage and resistance and check for pulses according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Signal Input/Output | Condition | Specified Condition |
|---|---|---|---|---|
| K21-1 (ILL-) - Body ground | LA-L - Body ground | Output | Headlight dimmer switch off → Headlight dimmer switch in tail or head position | Below 1 V → Pulse generation |
| K21-2 (EP) - Body ground | W-B - Body ground | - | Always | Below 1 Ω |
| K21-4 (INT)*4 - Body ground | L - Body ground | Output | ·
Power switch on (IG) ·
Steering pad switch assembly operated, "TPWS" selected on the multi-information display and "OK" switch (steering pad switch assembly) pressed and held → "OK" switch (steering pad switch assembly) off |
Below 1.5 V → 8 to 15 V |
| K21-5 (SI) - Body ground | W - Body ground | Input | Power switch on (IG), wheel being rotated | Pulse generation (See waveform 1) |
| K21-6 (+S) - Body ground | L - Body ground | Output | Power switch on (IG), wheel being rotated | Pulse generation (See waveform 1) |
| K21-10 (PBKL)*5 - Body ground | ·
B - Body ground*8 ·
G - Body ground*9 |
Input | Power switch on (IG), front passenger seat belt unfastened → Fastened | Below 1 V → 11 to 14 V |
| K21-11 (PODS)*5 - Body ground | L - Body ground | Input | Power switch on (IG), front passenger seat not occupied → occupied | 11 to 14 V → Below 1 V |
| K21-14 (FR) - K21-33 (FE) | LG - BE | Input | Power switch on (IG), fuel level full → Fuel level low (fuel level warning light on) | Pulse generation (See waveform 4) |
| K21-15 (FV) - Body ground | GR - Body ground | Input | Power switch on (IG) | Pulse generation (See waveform 5) |
| K21-17 (WLVL)*6 - Body ground | LG - Body ground | Input | Power switch on (IG), washer fluid level not low → Washer fluid level low | 11 to 14 V → Below 1 V |
| K21-18 (RLMT)*2 -Body ground | BE - Body ground | Output | Power switch on (IG), rear seat belt warning light LH off → Rear seat belt warning light LH on | 11 to 14 V → Below 1 V |
| K21-19 (RCMT)*2 -Body ground | R - Body ground | Output | Power switch on (IG), rear seat belt warning light center off → Rear seat belt warning light center on | 11 to 14 V → Below 1 V |
| K21-20 (RRMT)*2 -Body ground | G - Body ground | Output | Power switch on (IG), rear seat belt warning light RH off → Rear seat belt warning light RH on | 11 to 14 V → Below 1 V |
| K21-21 (ES) - Body ground | W-B - Body ground | - | Always | Below 1 Ω |
| K21-22 (ECU)*3 - Body ground | BE - Body ground | Output | ·
Power switch on (IG) ·
"OPEN" or "CLOSE" selected on "Rear Sunshade" screen of multi-information display and "OK" switch (steering pad switch assembly) pressed → "OK" switch (steering pad switch assembly) not pressed |
Below 1 V → 5.5 V or higher |
| K21-24 (RLSB)*2 - Body ground | SB - Body ground | Input | Power switch on (IG), rear seat belt LH unfastened → Fastened | Below 1 V → 11 to 14 V |
| K21-25 (RCSB)*2 - Body ground | B - Body ground | Input | Power switch on (IG), rear seat belt center unfastened → Fastened | Below 1 V → 11 to 14 V |
| K21-26 (RRSB)*2 - Body ground | LG - Body ground | Input | Power switch on (IG), rear seat belt RH unfastened → Fastened | Below 1 V → 11 to 14 V |
| K21-27 (OILW) - Body ground | W - Body ground | Input | Power switch on (IG), engine oil level not low → Engine oil level low | Below 1 V → 11 to 14 V |
| K21-28 (MSM+) - Body ground | GR - Body ground | Input | Power switch on (IG), up, down, right and left switches on steering pad switch assembly not pushed | 4.8 to 5.2 V |
| K21-29 (MSTI) - Body ground | R - Body ground | Input | Power switch on (IG), OK and back switches on steering pad switch assembly not pushed | 4.8 to 5.2 V |
| K21-31 (CANL) | W | Input/Output | - | - |
| K21-32 (CANH) | B | Input/Output | - | - |
| K21-34 (LST1) - Body ground*1 | L - Body ground | Input | "Ready to Refuel" displayed on multi-information display | Pulse generation (See waveform 2) |
| "Close Fuel Lid" displayed on multi-information display | Pulse generation (See waveform 3) | |||
| Power switch on (IG) | 11 to 14 V | |||
| K21-36 (TX+)*7 | G | Input/Output | - | - |
| K21-37 (TX-)*7 | W | Input/Output | - | - |
| K21-39 (IG+) - Body ground | LA-GR - Body ground | Input | Power switch off → Power switch on (IG) | Below 1 V → 11 to 14 V |
| K21-40 (B) - Body ground | LA-B - Body ground | Input | Power switch off | 11 to 14 V |
| K20-1 (ODO) - Body ground | LA-L - Body ground | Input | Power switch on (IG), ODO/TRIP switch (trip switch) not pushed | 4.8 to 5.2 V |
| K20-2 (TR) - Body ground | L - Body ground | Input | Power switch on (IG), light control rheostat up switch (trip switch) and light control rheostat down switch (trip switch) not pushed | 4.8 to 5.2 V |
| K20-3 (HAZ) - Body ground | LA-R - Body ground | Input | Hazard warning signal switch off → Hazard warning signal switch pushed | 11 to 14 V → Below 1 V |
| K20-5 (SW3) - Body ground | LA-B - Body ground | - | Always | Below 1 Ω |
| K20-7 (LR) - Body ground | LA-G - Body ground | Output | Power switch on (IG), RH turn indicator light off → RH turn indicator light blinking | Below 1 V → 11 to 14 V ←→ Below 1 V |
| K20-8 (B) - Body ground | LA-B - Body ground | Input | Power switch off | 11 to 14 V |
| K20-10 (TRNL) - Body ground | BE - Body ground | Output | Power switch on (IG), LH turn indicator light off → LH turn indicator light blinking | Below 1 V → 11 to 14 V ←→ Below 1 V |
| K20-11 (LL) - Body ground | LA-LG - Body ground | Output | Power switch on (IG), LH turn indicator light off → LH turn indicator light blinking | Below 1 V → 11 to 14 V ←→ Below 1 V |
| K20-13 (TRNR) - Body ground | BE - Body ground | Output | Power switch on (IG), RH turn indicator light off → RH turn indicator light blinking | Below 1 V → 11 to 14 V ←→ Below 1 V |
*1: w/ Canister Pump Module
*2: w/ Rear Seat Belt Warning
*3: w/ Rear Sunshade System
*4: w/ Tire Pressure Warning System
*5: w/o Occupant Classification System
*6: w/ Washer Fluid Level Warning System
*7: w/ No. 1 Stereo Jack Adapter Assembly
*8: for LHD
*9: for RHD
Waveform 1:
| Item | Condition |
|---|---|
| Tester connection | ·
K21-5 (SI) - Body ground ·
K21-6 (+S) - Body ground |
| Tool setting | 5 V/DIV., 20 ms./DIV. |
| Condition | Power switch on (IG), wheel being rotated |
When the system is functioning normally, one wheel revolution generates 4 pulses. As the vehicle speed increases, the width indicated by (A) in the illustration narrows.
Waveform 2:
| Item | Condition |
|---|---|
| Tester Connection | K21-34 (LST1) - Body ground |
| Tool setting | 5 V/DIV., 20 ms./DIV. |
| Condition | "Ready to Refuel" displayed on multi-information display |
Waveform 3:
| Item | Condition |
|---|---|
| Tester Connection | K21-34 (LST1) - Body ground |
| Tool setting | 5 V/DIV., 20 ms./DIV. |
| Condition | "Close Fuel Lid" displayed on multi-information display |
This waveform is output when the fuel lid opener switch is operated if the fuel lid is open and any of the following conditions are met:
The vehicle has been driven for 1 km (0.6 mile) or more at a speed of 50 km/h (31 mph) or more.
30 minutes or more have elapsed since the fuel lid opener switch was operated.
Waveform 4:
| Item | Condition |
|---|---|
| Tester Connection | K21-14 (FR) - K21-33 (FE) |
| Tool setting | 2.5 V/DIV., 20 ms./DIV. |
| Condition | Power switch on (IG), fuel level full → Fuel level low (fuel level warning light on) |
(A) varies depending on the fuel level.
Power switch on (IG), fuel level full → Fuel level low (fuel level warning light on) (4.1 to 4.6 V → 0.3 to 1.2 V)
Waveform 5:
| Item | Condition |
|---|---|
| Tester Connection | K21-15 (FV) - Body ground |
| Tool setting | 2.5 V/DIV., 20 ms./DIV. |
| Condition | Power switch on (IG) |
Power switch on (IG) (4.5 to 5.5 V)