When removing and installing the combination meter glass, make sure not to touch the display panel.
Do not allow any dirt, fingerprints, grease, etc., to adhere to the combination meter glass. If the glass is dirty, wipe it clean with a soft cloth.
83138G
1.REMOVE COMBINATION METER GLASS (for Type A)
|
Remove in this Direction |
Disengage the 8 claws to remove the combination meter glass.
83138G
2.REMOVE COMBINATION METER GLASS (for Type B)
Using a "TORX" driver T10, remove the 8 screws.
| *1 | Rear Cover |
Do not remove the rear cover from the combination meter assembly as foreign matter may enter the combination meter assembly and cause a malfunction.
|
Remove in this Direction |
Remove the combination meter glass as shown in the illustration.
Make sure to only remove the combination meter glass.